7" inch Black Slim Fan Push Pull Electric Radiator Cooling 12V 800 CFM Mount Kit Universal

This works really good. Moves lots of air

Incredible performance compared to the factory 8 inch radiator on my car would definitely buy again.

Bought one of those $6000 minis. The air cooled engine inside a metal box was no good. Would get way to hot in as little as 15 mins of hard digging. The gas was boiling away and a hydraulic cylinder would burn your hand. Just a small 7" fan was all it needed to be able to run for continuous hours. Hydraulics stay cooler as well. Zip tied it to the existing vent and cut a new switch into the panel. Just make sure what ever you wire it to can handle the extra amps. I ran direct power from the battery as to not mess with the factory harness. Have to reveres the polarity and the fan blades to be effective. Moves more then enough air.

I bought this fan to build a “redneck air conditioner” to use on our pontoon boat. In the photo, there is tape around the hole I cut in the cooler, but it’s not to hold the fan in place. There are screw holes that are perfect for mounting the fan. I reversed the fan blade, and reversed the wire polarity so that it would blow down into the cooler. The fan does this job very well, and keeps my wife cool. It makes a little more noise than would be ideal, but not so much as to be annoying. After all, it was designed to be under the hood of a vehicle! Puts out plenty of air, and does its job. Just one point to add: if you do this, make sure you have a second battery on your boat. You don’t want to try starting your engine after being anchored for a while to find you ran your battery has run down!

Got this to provide air circulation for trans cooler being used to cool a small high pressure air compressor used for Pcp rifles. Had to purchase a power converter to use it but all together makes a great system

I cooled down my new Steiner motor, I hooked it to the light switch

This was easy to install, quiet, and it moved a ton of air but it failed after 2 riding trips. I am not sure what failed, but if you jiggle the wires going into the motor it will cut in and out, but won't stay on. I used it on my sxs to pull excessive heat from the engine compartment. It didn't get wet, but it did sit by the engine and pushed air out of the side of the machine. I will be buying a different brand.

works better than factory one .