5 Pack of Adapter Bushings Converts 5/8" Down to 1/2" for Saw Blades

I have a 1/2" arbor on a 50+ years old Craftsman table saw. Unfortunately, the washer/bushing that tightens against the blades have cut outs near the arbor so I had to use three 1/2" to 5/8" arbor adapters to fill the space. I used two of these arbor adapters combined with one that was slightly thicker by another seller at Amazon: https://smile.amazon.com/dp/B000P4OCFK?psc=1&ref=ppx_yo2ov_dt_b_product_detailsIn the 1st photo you can see that the washer/bushing is thicker around the edges. In the second photo you can see the arbor bushing is also thicker at the edge. You can see the two brass colored adapters from this product and the aluminum adapter from the other seller.I made a work cart from 3/4" plywood cut on he table saw using the arbor adapters and had no issues.

Have an older table saw with a 1/2 arbor. Needed to convert to accept saw blades with a 5/8 hole. These fit perfectly to fill the gap. They were a bit pricey but after seeing them, they are quite small so glad I have 5 total so there are back-ups in case they get lost or break from extended use. Great overall purchase! Highly recommend.

My old saw had a 1/2" arbor but all blades are now 5/8". These bushings reduced the hole size on the blade and the saw works just fine.

Just what I needed to put new blades on my very old table saw. Perfect!

They are not quite as large as the add stated, giving a sloppy fit where a tight fit is needed- for a circular saw blade.No time to send them back, I had to 'peen' them at four opposing points to fit perperly, glad there were several for the first one I screwed up...

overpriced,worked

All blades seem to be 5/8 arbor ! My old right angle grinder has a 1/2 inch shaft. Now I can use the 5/8 arbor disks

great