1 x SabreCut SCRS1543HM Tungsten Carbide 240mm 2 TPI S1543HM Small Bricks Poroton Fibre Cement Concrete Straight Cutting Reciprocating Sabre Saw

Great on lightweight blocks but doesn't even scratch a brick. Used to trim out for a dog flap in the wall. Had to stitch drill the brick outside skin, but used this on the block work well

I need to cut some old bricks to finish the end of a wall. A brick chisel and hammer doesn't work as the bricks are so hard and full of faults they just crack or shatter.This blade cuts the bricks to size and on the red brick nice and square. It took about 5 min for each cut.The white brick took longer to cut and when I was just about finished - cutting from either end - it broke in half. Not the fault of the blade but the cut wasn't as neat. I assume this brick was a lot harder.The blade looks like it has plenty of more cuts in it and I am very happy with the results.Obviously dust is created but no where near as much as a angle grinder and there is quite a bit of vibration so the brick needs holding down well.All in all a very good purchase.

Used this to cut out the joints on the bricks to replace them so much quicker then drilling them out did to boiler flues in no time so will buy again

Very strong blade. Great for removing bricks by cutting out the mortar, just need to watch out for metal wall ties which can damage the teeth. Cuts through breeze blocks and aerated concrete like a knife through butter. Air born dust generation is low and easyto control. It does struggle with red brick and heavy concrete, I prefer to use a disc cutter or chisel for these. However, the blade is excellent when used on appropriate applications.

Needed to remove some bricks for a cavity tray and these did just the job. Well happy !

Does the job great

Was surprised as was bricking your chimney hole and needed half height bricks. Don’t have an angle grinder do saw these fit my reciprocating saw. Yes cut through a red brick took about 5 minutes as it was along the length. But done the job.