11T SRAM/Shimano Steel Bearing Jockey Wheel Pulley Set for 10/11Speed Sram Red/Force/Rival, Shimano Dura Ace/Ultegra 6700/6800/7800/7900/7970/9000/9070 Road Cyclocross Gravel Rear Derailleur

Used these on a 10speed Sram force derailleur and it cleaned up the shifting big time. The tooth profile also is better on the top jockey wheel and aids in a snappier shift. 10/10 will buy this brand again over factory!The bearings are nice w zero lateral play unlike the worn out Sram bearings. I’d probably bet they are a better quality bearing than SRAMsI’m using this on a 1x 10 speed setup w a short cage derailleur and goat link on a 11- 34 t resr cassette. Shifts perfectly!

Break open the seal and removed the grease. Cleaned with WD-40 and compressed air. Used WD-40 as lube. Perfect!

They go round and round just like they’re supposed to do.

These jockey pulleys appear to be much higher quality than SRAM which have cracked on both my Red and Force equipped bikes. HOWEVER, looks like I have to go back to the drawing board since NO INSTRUCTIONS were included. I put the top pulley on the bottom. And I still have no idea which pulley should house the lone brass insert.

it is not compatiblebecause there is a differencebetween Sram and Shimanoit is better to buy the genuineThanks

I certainly wouldn't have ordered this if I knew it was made of plastic.

This product works great on my 3x9Trek 2006 1500slr roadbike.What a great upgrade jockey wheels