Klutch Welding Table Clamp Kit 4-Pcs.

For hobby/home users with thinner plate fixture table, 16mm holes, these are perfect. The threaded nut helps lock the clamp, since the table top is rather thin for wedge anchoring.

These are fine clamps for a welding table if you are an occasional welder, or for hobby use. I certainly don't recommend them for a welding shop or in any application where they are used frequently. For my purposes where I am welding occasionally, or for general repairs, they work fine.

The product worked great and the clamps are very versatile.

Not really suited to my 3/4" inch holes, and I don't like that they have to be bolted through, but they should work for light duty.But they will work for 5/8" and 3/4"

Well theses nothing to not like about the clamps,very study easy tighten think down stays in place,

These will not fit a 16mm hole table without using a bolt underneath to secure. It says Clamps can be fixed on the 16mm holes of a welding table, but you would think they also slip fit. Not what I expected and to return I have to pay shipping. So literally throwing them away!!!

I bought this set to use with my 2' x 3' x 3 mm moveable welding table. The base of the clamp rod is threaded and has a nut that goes under the table. This is an advantage for a thin welding table like mine. You might not need the nut with a thicker table. As stated, these clamps are designed for 16 mm (0.630") holes and the step at the bottom of the rod has a diameter of 0.625" which gives a comfortable clearance. The stamped holes in my inexpensive table were only 0.622" diameter, so I turned the step down to about 0.617" and they work fine.

I expected these to be like other clamps of this type. I expected them to be able to drop into a hole on a welding table and be able to be used from there. These actually require you to screw a nut onto the bottom side of the table. Just really take away from the convenience of these types of clamps.