Left and Right Drive Wheel Module Pair for Vacuum Robots - Compatible with iRobot Roomba 500 600 700 800 900 Series

Fast to replace and it was amazing how worn out the old ones were.

Replacement was easy, and so far it works as well as the original.

Bought the wheels for my j7 doesn't fit, don't let the title fool you.

These wheels were easy to change out! She was back in business right after!

The price of these wheels would have been right if they’d fit the iRobot 800.Don’t the promise that they would fit when they don’t. Am very disappointed.

Easy to install in a Roomba 560. No instructions provided, but those are easy to find from a Google search.The treads are noticeably thicker than the original ones being replaced. One of the new wheels was missing a screw, but we used an old one from the prior wheels so no problem there.Roomba seems better than it was before (our 560 is a few years old), finding its way home without issue getting stuck somewhere. So far so good.

Got these as replacement wheels for my ca 2014 Roomba 880, and they are a perfect fit.They work well so far, no issues to report!installation is a breeze, all you need is a Philips head screwdriver:- Remove little yellow corner brush- Remove battery cover (2 screws)- Remove screws holding the bottom cover on (1 one each side).Voila, you can now lift off the bottom coverEach of the wheels is held in by two tiny PH screws. Loosen these and you can (carefully) lift the wheel modules out. There is a connector at the bottom side that provides the electrical connections for the motors - make sure not to damage these.To put the new modules in just repeat in opposite order. The whole exchange should not take more than 10 minutes start to finish.If your Roomba has issues with the wheel modules these are a no-brainer. Cost-effective and super simple to install.

I went to work on this as soon as it came in today, the mental grinding sound was really unbearable to listen too. Simple to remove the old ones, remove the battery plate and the two other screws near the wheel modules that takes off the back plate to get to them. From there there is only three small screws holding the old ones in place remove those and remove it and place the new one in and screw it back in and the same with the other side and simply put the rest back on, Very simple!!