NcSTAR NC Star MAK, AK Receiver Cover Picatinnyx 40mm Mount, Black

Did not fit my Ras47

I was unable to get this to fit my Arsenal SLR-104 even after following the directions to grind it and get it to fit. However the rail itself is high quality. It may or may not fit on different ANd.

Bought as a cheap experiment but does not fit on Cugir Draco. Tried filing the top of slot for the recoil spring button to clear but still would not sit flush in rear trunion gap. My guess is this is the reason some other have reported it flying off during firing. The original part is a very tight fit so I guess its no surprise. Guess I will be opting for the considerably more expensive TWS model in future. So close but so far, get what you pay for...

I expected to so some filing on the upper opening where the recoil spring holds the dust cover, Im thinking you must too. This is due to the conversion from cm to in, its never precise because the nature of how both measurements go.If you buy this piece I would recommend you compare it to your current dust cover and try fitting it in to see what you need to file off. Im sure it was made in China (like everything else.. dont kid yourself, our country doesnt make anything anymore [thanks to CEOs])

I got it for my AK-47 Airsoft fun and it didn’t fit at first. I had to pull out the prong on the front and force it down then put some tape on the front of it bc the button on the back kept it in. Only had to use a few pieces tho other then that it stays in well

Looks good, but did not fit my Century Arms RAS AK47 even after trying a gunsmith s recommendations to grind down the front peice. Two screws in rear of cover are useless. What are they for?

Don't fit YU N pap; Quality great; Finish Great Worry free return.

This product looked fine. But it didn't work for a Draco pistol. The cause, the square hole to lock it is offset, almost 1/4 inch. Locks but with gameplay. Don't work.