2 Packs Car Dent Puller Kit - Powerful Car Paintless Dent Remover Auto Large Small Dent Remover Tool for Car Repair, Glass, Screen, Objects Moving

I have these dent pullers in two sizes, both are best for the initial pulling of larger and round dents. (Such as a kick to the door or jump on the hood) Harb FR has an air compressor attachment for around $70 that really pulls hard, larger dents, also but I would start here with cheaper and easier. Just keep your surfaces (tool and vehicle) clean. Spray both with alcohol and rinse with water and dry. Careful using tool if paint is not original from factory. Also, have patience, it will likely take multiple pulls before you start to see results. I'm no pro at dent repair, still learning, youtube is very helpful also.

These gadgets works well for me.The suction power is awesome.Car dents can be perfectly repaired as long as you follow the steps exactly:“Dent remover tool for car must be used on clean,smooth,flat,non-porous,dry surfaces. Make sure there is good suction before lifting. When dealing with car dent,please ensure the dent is on a flat surface and the diameter should be large than the diameter of the bottom of the suction cup. Before using the suction cup, pour hot water on the dent area. After that, quickly place the suction cup on the dent of the car, and then pull it out horizontally. "The above operations focus on the following points:1. The dent must be on a flat surface and not in a curved position, because the suction cup of the repairer can only be used for flat surfaces;2. Before use, 100 degrees of hot water must be poured on the corresponding dents. I guess it should be the principle of thermal expansion and cold contraction, so that the operation can make the puller play the biggest role, and it is more labor-saving;3. Before the puller absorbs, the dust, water and other things that adhere to the surface of the dent must be wiped off, so that the suction can be maximized;4. Large dents may not be fully repaired in one times, and need to be repeated over and over again until the dent was fully repaired, but it's worth it.Notice:The puller core for small dents is non-metal, so it cannot be used on large dents, otherwise it will easily break, so you need to be careful when using it; the large puller core is metal, very strong, and has greater suction! A small dent puller has saved me a lot of money on car repairs and I would definitely recommend this great little tool to all car owners around me! awesome!

It worked great for me. I had a minor dent from either a vehicle or rogue grocery cart - parking lot unattended damage. The dent puller took most of it out. I could probably take the rest out by pouring hot water over the area while pulling, but haven’t taken the time.

Not a bad item but it only works on flat surfaces so it couldn’t pull my dent out my car I have a small dent so though it would work

This didn’t get the job done that I needed done. The larger cup couldn’t get a grip and the smaller cup wasn’t strong enough to pull the dent out.

The dent pullers are a simple design yet effective at removing dents from car body panels. Sometimes you may have to work with the metal a little before the dent pops out. You may even have to apply a little warm water to the metal to get the dent to pop out, but don't heat the metal too much prior to using this device as this device is made of rubber and plastic.

So I tired to use it. The device suction didn't want to stick to the area of the dent. In fact it didn't want to stick to any surface.

The smaller of the two products, the one I really needed to perform, had woefully inadequate suction to pull the small dent in my car. It fit the dent well but would not give enough suction. Disappointed for sure.