BIFALE XLR Splitter Cable 1.6ft, Nylon Braided XLR Cable 1 Male to 2 Female, Y-Splitter 3Pin Balanced Microphone Cable

As advertised. It's a little stiff like the other reviews said but I'm not moving it so it's not a big deal to me. Feels sturdy

love the cables. Purchased the 25' length. Had one cable become defective about a year of use. Contacted the seller and they immediately not only replaced the defective one, but sent two cables for the trouble. Wished most products and sellers were as good as I've experienced with these.

To start, I wanted to buy some cables for a couple of uses, short haul studio connections and also for my office listening setup. Both of these benefit from great, well made, consistent cables. What I mean by consistent is that two six feet cables are as close as possible to being the same in regards to its electrical characteristics. I test and measure (not size, distance, but for resistance and flow of voltage/current and also RFI/EMI) cables before they are introduced to any of my gear so the cables don’t introduce artifacts that alters the audio in a negative way.Here is what I found. The cables are very consistent so I did not get any channel imbalance in stereo (L/R) applications with 2 of their cables, did not pickup any external noise, and was very clear with minimal resistance.The build quality is excellent, but my use case is install it and use for the office, and the studio use is patch, use until sessions are complete, then disconnect for future session. So I hope the ends will last a while.The cable is very rigid so as you unravel for the first time, make sure it is straightened, then shape into angles of choice while still avoiding hard 90 degree angles.Does it improve the audio over some very expensive cables that run a minimum of $10-$100 per foot? In some cases, yes. Some of my expensive cables are thinner, more sensitive to pick up EMI/RFI noise and the dreaded cell phone modem like noise. I have filters for that through shielded conduits but that adds another $5 or more per foot of shielding at bulk.To conclude, you can’t go wrong with these cables. They are built well, have not had problems with either termination connectors, and the sound is excellent with minimal to no noise added to the audio chain.I’ll continue to buy these as needed, as long as they keep manufacturing them.Hope this helps.

I have other nylon and braided XLRs that I love. I got these and immediately found they weren’t flexible enough for my use as a mobile event DJ. They tangle and are difficult to wind and unwind into storage. Maybe in a static use they are ideal, but if you are having to set up and break down consistently, I would find another XLR.

For the budget not bad

The cables arrived as promised. Great customer service. The cables are high-quality and a great value for the price. I recommend both the product and the seller. As I have need, I will definitely purchase from this seller again.

Three out of the first four cables I tested (from a set of 10) were defective, showing intermittent shorts in my cable tester. Stopped there and sent them back, and left a poor review here.Then I was contacted by the manufacturers directly, and they offered to send me a replacement pack. I agreed. The new 10-pack is really just two of their 5-packs, so I didn't get all of the colors shown. But, I tested all ten cables and they work fine. Used half of them at rehearsal this weekend, and they worked as intended, no problems with the connectors or anything else. So, I'm revising my review here to reflect the fact that they reached out and wanted to make it right, and they did. So far, so good!

From now on these will be my 'go to' cables in studio and on location. Excellent. Most cheaper cables have irregular sized fittings on the end meaning you have to push uncomfortably hard and pull uncomfortably hard when inserting or removing them. These cables have a precision of design and fit worthy of anyone's studio.

Quality chords roll up nicely without getting all twisted

These are very stiff making them hard to use and the connectors are very cheap.

Connects my processor to my amplifiers with no noise or interference.