HICTOP Ender 3 Thermistor 1.2m/47.2 Inches NTC 3950 100k Thermistor Temp Sensor for Reprap Creality Ender 3, Ender 3 Pro, CR-10 10S 3D Printer 2Pin XH2.54 (Pack of 5)

I've purchased thermistors from several other sources and these ones were the best quality of the bunch. They had acceptable manufacturing, ok insulation length before the glass bead. I was hesitant because the wire gauge is somewhat thinner than some of the OE thermistors. However, they work great! No issues with them. They were slightly difficult to seperate from eachother but it was far from the mess I received from other sellers. I would reccomend this seller/brand. Used in aquilavox printer, no pid tune, worked fantastic.

All test ok, read around 100k@25c +/- %Only 4 stars though as no matter how carefully you try and undo them and get one out then they all just birds nest into an impossible mess, maybe supplier can bundle them up individually regardless of packet contents instead.If they do nest up then just use some tweezers or similar to push pin tabs in and pop of the plugs and have them untangled in a few minutes.

Tangled up beyond belief and most are unusable because of it

These thermistors seem to work fine fine, but like some others state they come all rubber banded in one clump. Took some time to untangle.