CondorElite US1025-002 Tsrs Shotshell Strip Black, 6.5" L x 2" W

So like another reviewer pointed out, this shell carrier has the loop side Velcro and comes with a double sided hook/hook Velcro strip. What I didn’t realize is that there was no adhesive to attach this card to my shotgun included. Once I purchased some adhesive Industrial Velcro strips I was finally able to test this product fully.The loop Velcro attaches well to the hook Velcro I got elsewhere. The elastic shell holders hold pretty well too. I took this out to the range because another reviewer pointed out that shells fell out of the elastic while shooting. I shot various shells at the range and no shells fell out of the elastic. I did note some shells had shifted very low close to falling out after I shot a few 3” buckshot shells and 3” slugs. I can’t tolerate the recoil on 3” buckshot shells for long so I didn’t shoot too many of those. I load my shells with the primers up by the way.Once I obtained adhesive hook Velcro to attach this to my shotgun it was good to go. I tossed the hook/hook Velcro out. Useless.

Believe it or not, these things are actually stiffer than the Esstacs! Two full layers of stiff nylon for the base instead of one nylon layer with a stiffening rib. Hefty pull tab. Proper sizing and spacing of the elastic loops to mount shells uni-directionally, with a little gap between shell rims.Oddly, these are made with loop on the back side instead of hooks, but Condor fixed that by supplying a double-sided hook strip. However, there is no way to make sure the strip stays attached to the card and doesn't stick to your scattergun or your vest. I could see using a wire tie around the card at both ends to prevent this, but it would be far better if Condor made these as hook instead of loop.Also, only six rounds. Still, I like these cards. Are they superior to SKD Esstac overall? No. But I like them well enough to probby get more than the two I have now.Supplement: Use Weldwood contact adhesive (Ace, Home Depot, Lowe's, etc.) on the back of the card loop. Attach the hook-to-hook panel. Allow to cure. Separation problem solved. Plenty stiff, too!

This is a great way to carry organized shotgun ammo. My ammo bag that I take to work with me (Sheriff's Office) has velcro tabs on the outside that these cards can be attached to so when the first card on the shotgun runs out. I can just peel off the old one and slap a new one on from the bag. This is much better than the old hard mounted side saddles.

Great product for the price point. Though I have not had issues with the loop tape coming off my shotgun (because I degreased it before putting the tape on), I only have one complaint about the product. It seems to warp on its own, and bows in a direction that most of the velcro in the center of the card does not contact the velcro on the gun at all. This causes shifting when shooting my shotgun. So far, my fix is the take the shells out, and leave it between two loaded ammo cans to get it flat again. This fix has been successful. I suggest a stiffener that does not warp. Still, a great product for the money, and I will continue to use it.

Two layer Velcro system, you can remove the outer strip to get the other side of the Velcro if you want. Shell holder retention is very strong. I use these as essentially "extra loaded mags" with Velcro strips on my shotgun for quick ammo access. These also fit great to the bottom of truck seats that have the carpet type fabric on the bottom side. My backseat will fold up and these stick great to the carpet-like fabric. Quick access in the vehicle if needed.

Works well, I'd of preferred the hook part of the velcro being on the shell holder, not a double sided strip that's separates from it.

Nothing wrong with, it's good, it's handy, fits in an AR-15 pouch, can quickly replace a spent saddle. It's good, I just don't love it and the fabric seems to break in and wear out fast, I still don't understand why these can't be made better.. Only explanation would be penny pinching on fabrication costs or stupidity. It's good for keeping shells organized in an AR-15 or similar pouch or any bag really, for grab and go, or as suggested slapped onto the stock or your MOLLE Velcro to keep one hand free for rapid reloading, But overall it's not reliable. Only time I keep this on the gun is while it's stored and not loaded for rapid loading. other than that I wouldn't slap one of these onto the stock sleeve until ready to reload. I'm sure as others have mentioned eventually the shells will fall out while shooting.

Very good quality product I just ordered a 3rd strip today , just use the industrial velcro ( have to buy separately ) with this Reload Strip & you've got a 6 shot reload on the left side of your gun mounted firmly .

brilliant product,thanks

Tiene il peso delle cartucce. Tutti i tipi. Bande elastiche strette. Non lascia andare le munizioni nemmeno sotto gli scossoni del rinculo del 12. Per evitare di trapanare o alterare arma è una Alternativa valida e mooooolto economica. Sugli strap del velcro, esiterei un attimo ad attaccare e staccare in continuazione....temendo venga via anche la "femmina" sulla carcassa. Ma se lo si lascia su, fa il suo

Habe es seitlich an meine Pump Gun mit Klett angebracht.Stört kein bisschen und was nützt eine Waffe wenn man nicht genug Reservemunition dabei hat! Und genug hat man selten.Hält die Muntion bestens an Platz und lässt sich gut herausnehmen.Super Kauf.

Für Softair-Schrotpatronen leider viel zu eng und keine Klebefläche auf der Rückseite.Schade.

Ok, produit conforme à la description. Cartouches de 16mm un peu dures à entrer mais elles sont bien maintenues !