Belvedere 17009B Dryer Cart For B900C Dryer

Like others have mentioned I don't have the exact model, I'm pretty sure my Belvedere is a little older. I got it used but wanted to use it with a normal chair.It props up on the little bit above the wheels (it'd be nice if they included a pic) and has two slots on each side you are to screw in (they include the screws). The screws are 1/4-20 X 1 1/4 'thread cutting screws'. The instructions say to flip your dryer over and remove 'red plastic sealing plugs' (apparently with a screw driver). Since mine was used I had no plugs just a few screws already in and 4 holes that seemed like they were where these should go.Problem was my holes were slightly smaller than the given screw size. So I grabbed a few smaller ones (I don't know the size, probably one size down) and that worked perfectly. However it was slightly off and I only could get 3 screws out of 4 but it was plenty and seems stable.I went to Belvederes site and I also googled and it seems the ability to purchase any other model cart does not exist. So its up to you to take the risk if you don't have the exact model, but I'm pretty happy with it.

Fits my used Belvedere dryer perfectly screws seemed a little big for model but did go in. It sits on an angle which I think is perfect for rolling up to a chair.

This was not easy to screw on but once once it was finished it held the hair dryer upright perfectly.