Adhesive Copper Foil Tape - Double-Sided Conductive - 0.25 inch (6.3 mm) - EMI and RF Shielding, Paper Circuits, Electrical Repairs, Grounding, Arts and Crafts, Home Interior (2 inch (50 mm))

I use the double sided adhesive on craft projects, some of which I sell. So it's important that what I stick down with it stays in place for the long haul. This has. Some of the trims I use are very narrow and others are wide and larger pieces of paper or images are all things I use it for. It comes in a wide variety of widths which is perfect for my needs.

This tape works. You just have to take your time with it, and have a plan as to how you're going to use it and make sure you can apply some pressure to the tape for about 20-30 seconds to make sure it bonds to the surface. I would recommend this tape definitely.

Difficult to split

Easy to work with and worked well for the art project it was used for.

We use this around the legs of our raised garden beds to prevent slugs. It works great and lasts about 5 to 6 years depending on location of beds and weather.

Slugs are not getting into my crop now.

It works well for me. Used it to hold insulation together on edge

Great product!

Everything as pomised. Came in express time. Like to use it, couse I Knowles it will hold my craft project as I want.

Easy to use and very sticky

It did the job I needed it for and it worked well.

As described.. no problem.

Using this to make DIY capacitive touch pads for an ESP32/Arduino project (see photos showing wire soldered to a rectangular copper pad made from this tape and an adhesive copper pad stuck directly to the inside of a polycarbonate enclosure).Solders easily with standard multicore lead solder and the solder heat (using here 305 deg C) does not distort the copper or bubble the adhesive on the back with short periods of soldering - the heat quickly spreads evenly throughout the thermally conductive copper rather than melting the adhesive directly below. Works really well for soldering to and solder flows nicely on the copper surface.Adhesive on the back is strong and will reliably stick to polycarbonate project enclosure box sides without lifting or curling at the edges. Polycarbonate has a reasonably high surface energy and I would expect the tape to stick well to similarly high energy surfaces.An ideal low cost tape for RF shielding on projects or for making things like capacitive contact pads. Not too thin and holds its shape when you come to stick it to something. It may crease slightly when removed from the backing, particularly if mishandled, but is easily smoothed out when applying to get it looking flat again. Tests with continuity meter confirm the adhesive is conductive, I measured about half an ohm from front through to the adhesive back so you could layer and overlap multiple strips of tape inside an enclosure to provide shielding to all sides.Recommended.