Wide Voltage Range Cool White DC 12 Volt to 24 Volt Lighting LED 11.8" LED Light Bar Aluminum Rigid Heavy Duty Linear Lamp Strip Off Grid Deep Cycle Battery Landscape Solar Marine Tiny House Cabinet

The product description for the warm white is not correct. From a power consumption point of view, this light uses less than 1 watt, while the cool white uses about 4 watts at 12 volts. The actual brightness seems proportional. While the light is much dimmer and uses much less power, this worked out very well for me. From the product description it was hard for me to tell what I needed, so I bought one of these and one of the cool white. I ended up using both over the dining room table in my backwoods trailer, adding an extra switch so that I can choose one or the other. I also can do both, because sometimes mixing cool and warm makes a nicer light, but I haven't found that to be useful in this case. While the cool white lights up the area really well, this warm (not so) white is great when I want a more subtle lighting experience. It lights up pretty well, but isn't great for reading or doing some other task where full light is needed.

I bought 2 of these 24V LED stripa for my 3D printer. Been running them on the printer for about 8 months when today the lights on one strip start flickering. While I'm watching they go out, smoke starts coming out the end of the tube, and there are flames visible inside. I killed power and immediately disconnected the string of lights. The other strip is still fine though honestly not very trusting of it after this event. These are hooked up to a genuine meanwell powersupply though a big tree tech skr 1.4 board. The power supply and Baird are not the issue as the other everything else on the printer is running fine. I would stay clear of this product as this is a definite fire hazard.

Just as described. All good. Mounting took awhile.Update: The first one I bought is still working just fine about a year later. Bought another just now and installed it in cabinet/closet in RV. Now that I get how to mount them, it took 5 minutes. Tip: Use very small flat headed screws.

Something's missing between the two ends of bare wire on the light strip and the finished appliance/device end of the transformer. It should have been noted that the missing/additional part(s) must be purchased in order to make the connection. Shouldn't have to hire an electrician for something this simple. Just tell me what I need and I'll get it.

Good bright light. Only negative is that connecting wire is pretty thin gauge, so you have to be careful working with it, it would be nice if it were a little heavier gauge to match normal wiring.

Awesome, hard to find item. I used them to sublight a coral forest art piece Easy to wire. works well on a nine volt battery.

Worked great. Kept Chickens Laying

This was a great and super bright light until I tried to use it with my 12V Cabelas battery and it blew. It could have been my shottly wiring job, but the light blew none-the-less. :-(