JAYEE 20 Pack Drip Irrigation 1/2" Drip Tubing End Closure Stop End Cap Plugs Fitting Kit 17mm for Garden Greenhouse Patio and Lawn Agricultural Watering Applications

Fit and work well to close end of 1/2 inch poly tubing.

Good quality easy to use

Low cost and have never come loose or leaked after several years (2+) of use. Not affected by water hammer that can occur on long runs that can pop other fittings out of the end of the tubing. Also easy to remove, unlike most other drip fittings. Not extremely size sensitive like other drip fittings.

There are multiple outside/inside diameters of 1/2" irrigation tubing with Rainbird being on the smaller end of the scale and Toro Funny Pipe being on the larger end. This clamp fits well on the Toro but the smaller diameter of the Rainbird allows this clamp to easily slide all of the way back to the folded joint loosening the connection. Zip ties can also work well.

Hey, not a lot to say, as these are pretty simple figure-8 1/2” drip-line end plugs. They seem pretty sturdy, so should last a good while. Just make sure you leave enough length from the last emitter to fold the end over to make it easy to run through both holes of the closure.

Not much to say for this practical and reliable solution. Recommended.

Works well for the .600" ID x .700 ID tubing. Some similar products sold to fit 1/2 inch Irrigation tubing are too small. I would buy again.

Finally, a figure eight that fits .710 drip hose. .710 uses blue fittings, not green.