Powell PeraltaPowell-Peralta Tail Bone Black, 8"

I bought this for the Powell Peralta Steve Caballero Chinese Dragon reissue deck I ordered at the same time.It fits perefct as is. This is technically a 10" deck but the tail is about 8-1/2" wide.The bone is exactly 8" and it's not too stiff. It was easy to clamp it on to the curved tail of the deck.I used a countersink bit to get the screw heads just below the surface and as it's a new deck, I was able to do it before putting the grip tape on so you can't see them now.I scanned the included instructions so everyone can see them before buying.

Used for doing spins, instead of wearing down the board, the bones take the beating. Very helpful!

I had to trim it to fit on my LandYatchz board. I traced out the fit and used a table grinder to get it to size. Then I drilled holes with a 1/8 bit and then counter sunk the hole with a countersink bit. Then clamped it to the board and drilled the holes and screwed it in place.

Product as described good price and fast shipping

Good product overall, will most likely need to cut to fit your deck though, unless you have a tail thats 8" or wider. Only thing I dont understand is why the side that goes against the deck is the side with the countersink holes, just doesn't seem right.

Sweet! It needed shaped of course. This is what I did maybe it will help someone. I put painters tape on the back of it and then clamped it on my board where I wanted it then I cut away the tape that was showing. This gave me easy guide on what to remove. I put it a vise and used a flap disc on a grinder. It worked good. I also used a counter sinking bit on the top side of the board so the screws were flush.

This is a badly designed tail bone that will split your layers with the included hardware

This product was possibly wide enough to fit a 10" board. It fit my 8" board like a whale tale. I had to cut it with a hacksaw and mold it with a large file. Looks and works good with extra effort.