Wireless Remote Switch with 2 Remotes, 30A Relay RF Switch for Pump | 433MHz AC 110V 120V 240V 328ft Long Range, ON/Off Kit for Fan Motor Dust Collector Ceiling Lights Electrical Equipment

I used this with my dust collector (110v) in my shop. It works great. There are a few things to note: 1. If you accidently program your remote incorrectly (ie, put it on momentary mode like I did), you can reset the unit by pressing the program button 8 times. It will then flash the led 8 times and all remote information will be forgotten. You can then program the remote again. I didn't see this listed on the page and didn't get a manual with the relay. 2. If you are using this to switch something that has a high current draw (even if it's within spec of the unit), do yourself a favor and throw an AC contactor in the mix. Take the current load off of the controller. You can pick up a Baomain 2 pole AC contactor for like $10 new. If you are running lights, I wouldn't worry about it, but it's well worth the setup to isolate your load from the switch for a motor or compressor, etc.

Great little setup for a remote control switch easy to use and program. I paired with a contactor to make a switch for my dust collector. I originally wired this switch to 220 and a 13 amp motor worked like a charm for a year then burned up. I paired it with a contactor this time should last forever.

Don't buy this product. I'm an electrician for 30 years and when I seen this product for some low amperage lighting I thought oh this is a cool solution. Right out of the box this product didn't even work what a joke. I ended up purchasing Solar lighting to resolve my lighting issue. This product is cheap do yourself a favor and save your money. I would give a negative star if it was available

I needed to remotely control an overhead Big Maxx heater. I was pleasantly surprised that after READING instructions the unit works flawlessly. My home is approximately 200ft from the garage and I turned on the heater from my recliner. LOVE it and highly reccomend this controller.

They need to be specific about 220. The 2 hots go on the input side. Range is ok but more like a tv remote.

Bought this to replace another brand that was DOA. Sent that back and got this one as a replacement and it works great. Easy to hook up if you have a basic knowledge of electricity and wiring, just be safe. Would definitely consider this if I ever need another one.

Installed today Load and Neutral input as marked on switch. Load and Neutral output as marked on switch. Ignore the enclosed diagram. Turns my 3/4 hp, 110 volt, pump on and off as advertised. Great buy, great switch. Remote control switch programmed just as the instructions directed--very easy.

I purchased this instead of a $100 dust collection trigger. With some simple electrical wiring it saved me nearly $80. Range is good, remotes feel solid. I'll be getting another to add to my system.