10-Ton Hydraulic Gear Puller with 2 & 3 Jaw 10" Reach

I needed a puller to remove the flywheel from the crankshaft of an antique car. I was concerned that the puller might not be able to fit the 3 inch hub of the flywheel, but it did so easily, and I quickly got the flywheel off. A great tool!

Product worked great pressing out my stuck cv axle that i spent over an hour on pounding on the shaft my my heavy duty air hammer and 5 pound sledge hammer to no avail. I ordered this product as a hail mary attempt to remove the stuck axle from my hub. Side note, this will take two people to use as holding everything in place with one hand isnt possible and pumping the handle with the other. Once i had the tool setup and in place 4 pumps and two loud pops later the axle was free. Took 20 seconds to free it up. Will worth the money spent.

Pulled a rear disc on a 2016 Town and Country. I chose the 15 ton version simply because I have experienced too many tools that were just not capable of doing the required job. A heavier version is always money well spent. The only restriction is the 2" travel limit. With the deep pocket in the hub, I had to use a 2" length of 1/2 steel pipe to be able to get a set-up that would work. Then, popped the disc right off.

Works a few times pulling seized axles. I got a few real stubborn axles out with this tool but eventually the bottle jack portion stopped working. Lasted about a year pulled 5 axles or so.

I liked the power but the throw was so short I had to improvise with a socket. I wish that the video was more honest. I would have saved time. Once I got to get the hub assembly to move the hub moved this thing had actually bent the hub. Worth it yes. I tried heat I tried penetrating fluid to get everything off I did everything that any normal person would do. Yes it was heavy for one person to use but if you use a jack stand to hold it up while you are positioning it and putting pressure on you'll be fine. If the two if you have two people then it makes everything there's a lot easier but I did not have the option. What are the recommend this to others yes but you had better either have somebody help you and remember that's only a 2-inch throw. I am still glad I had bought this piece of equipment because I will use it again.

Very powerful. Very high quality.

Works really great and pull the bearings I need to get out and I’ll use that many times in the future

Bought this for a project and ended up not needing it. Sat on the shelf til today where I needed to pull a mower idler pulley that was locked on tight. This made the job effortless! Great power and overall decent build quality for the price!

Este extractor lo use para una motobomba hyundai, le quite el impulsor centrifugo que media 7 pulgadas de diametro y compre el de 8 pulgadas y quedo perfecto, el producto viene con una caja para que guardes tu herramienta, esta excelente este extractor lo volveria a comprar super recomendado,

Works exactly as you would expect it too. Assembly is simple. Hydraulic pump is easy to use and applies good force. Used it to pull drums off stuck brake shoes. Worth the investment.

El producto está fantástico pero me llegó de menor capacidad y no me sirve muy bien para mi necesidad

Best Thing to have in your garage, You can pull, bearing, disk brake, you can do everything with no hard work, just pump and it do the work, 30000 Lbs of force, 15 Tons, of hydraulic power...

Dice que es para 15 toneladas Y el equipo tiene 5 Ton