🔑 Unlock Convenience with Style!
This Key Fob Keyless Entry Remote Shell Case & Pad is a perfect replacement for various Chevy, GMC, Hummer, Pontiac, Oldsmobile, and Isuzu models. It features a durable design that requires no reprogramming, ensuring a hassle-free experience. Weighing just 0.634 ounces and measuring 1.25 x 0.5 x 2 inches, it’s the ideal compact solution for your keyless entry needs.
OEM Part Number | 10335582, 10335583, 10335585, 10335586, 10335587, 10335588, 9364556-4575, L2C0007T, 10335582-88 |
Manufacturer | USARemote |
UPC | 688946479083 |
Item Weight | 0.634 ounces |
Product Dimensions | 1.25 x 0.5 x 2 inches |
Is Discontinued By Manufacturer | No |
Manufacturer Part Number | g-4575-2b-case |
M**E
Instructions.
It is a little more complicated than I expected. I don’t use QR codes as well as maybe I should. Some instructions for it would have been helpful.
S**D
vehicle remote
came as described. works great
J**R
Defective
Defective. The place were the battery terminal goes isn't cut out of the plastic so there's more way to install it. The first photo is the new cover and the 2nd photo is my old cover for comparison of where the terminal should go.
A**.
Easy installation
The item fit as expected. Now my keyfob is brand new. Easy installation
B**N
Works well with some adjustment
Came fast and my old fob internals transferred easily. Battery clip was present but the slots that held it in place inside the back cover were missing or uncut. After opening them up with a hot razor blade, there are notches where the slots belong, everything then went together easily and it works as expected. Taking away 1 star cause I had to mod it to work
B**R
Easy
Was easy to switch over!
S**L
The small metal piece is very important ! You must install it!
It was relatively easy to change to the new fob.
A**
Hope you have a Kinfe/ sharp cutting tool
I got this case because the ring hole snapped off my old one, so I had to carry it in my pocket and couldn't attach it to my keys. The case worked, looked nice, and had all the necessary parts. But the internal shell was too small, I spent a a few minutes trying to get the old circuit board in by force but was afraid I was going to snap it in half trying. And I tried a few different ways to get it in, from trying it with the rubber button pad inside, then trying to put it in the pad, and then the pad into the case, but it still was just barely too small. I ended up using my knife to shave a bit of the internal plastic off the wall to make it fit; regardless, it was still very tight. The other problem was with the back part, the little metal where the battery touches were not properly attached, and after further inspection, that's because the slits for the arms were not cut out, again, I used my knife to cut them, so it would fit. Unfortunately, the metal piece that came with the fob had the prongs too tight, so I tossed it and used the one from my old case. Overall, it works fine but be prepared to use your old parts, and don't be afraid to use a little force with it.
Trustpilot
1 month ago
1 month ago