Graduated Cylinder 10mL Glass Measuring Cup With Spout Wide Mouth, Conical Beaker Liquid Dispenser Measuring Cylinder Experiment Tool for Science Teaching

A little hard to read the measurement on the product. Seems to be sturdy enough and easy to clean. But, I think I will be changing to syringe for measuring it's easier to read.

The shape with the spout is great, and I wish it were better, but there are two significant issues after ordering 6 of them, and which apply to either all or most of them:1. 4 of the 6 have very faded measurement labeling. I returned the first three and they send three more and they all had the same issues, two were slightly better. Please note that I also ordered the 50 ml and theirs was very clear and bold.2. I have compared various measurements with both a Pyrex calibrator and a 4 E’s pipette and this measures approx 25% more each time than what it says. The picture shows a calibrated 2ml water liquid, which seems to indicated it was only 1.5 ml.Overall, except the useful shape, this seems to be a poorly made product that is very much inaccurate.

There was a time before I got this magnificent little measuring thingy. In the time before, if you told me a drink had one part gin, one part absinthe, one part st germain, one part lemon juice, and a dash of violet liquor, part would mean shot and I would be in for a rough night. Thanks to this little guy, I can make a normal human strength drink without trying to fill 1/3 shot glass 80 times. Came quickly, good quality, glad I have it

Works well, markings are easy to read and it is study. I have dropped it a few times and it didn't break. Because it narrows at the bottom in order to clean it you will need a small bottle brush.

Simply put, works as it should. It's glass, easy to clean. Hope I don't break it. 1st month, AAA.

Measurement marks on the measuring cup are inaccurate. I used two separate droppers to test....5ml from each dropper consistently read 6ml in the measuring cup. Poor quality, do not trust.

I have pretty good eyesight and I can't read the measurements. It's printed in yellow and even with good lighting it's very difficult to read.

I like the size, I like it was easy to read, it is glass so it is resistant to diesel and fuel additives but the ink labeling the ml grades comes off with diesel additive, the stuff I need to measure!!!! I measured about 10 times different qty of diesel fluid and at the end the ml markings were gone… I might try to etch the glass at the intervals between 1 and 10 ml… too bad , I thought I had a great piece to measure fluids…