Deck Plus 3 Inch Epoxy Coated Exterior Wood and Fence Screws #10 x 3 Torx/Star Drive Included Coarse Thread, Outdoor Rust Resistant Decking Screw, Red Rojo, 25 lb Box, 1550 Pieces | 48416

Purchased this brand Deck screw many times in various lengths. Out of the 5lb boxes, have yet to even break or strip the screw head. The Hex head allows quick install and removal of screw. no pre-drilling the hole required and mostly used on Treated lumber. Comes with a BIT for install but short type. nice coating so no rust yet. Claims Lifetime warranty on box.Same brand at Lowes and other retailers is at least $5 more for same size.AMAZON finally put this last container in a plastic bag to prevent spillage into the shipping box. That has not been the case until this order and many times had to cleanup a box full of screws putting them back into the container.

These are well machined and finished deck screws with features not found in other products in this category. Before you decide if these are the best screws for your project, it is important to understand the benefits of these various features. Starting at the top you will notice the star or “torx” drive feature. One can reasonably assume that 6 point on the star is more than 4 points on a Phillips screwdriver, therefore, because more is better, the torx will outperform its ancestor. However, the truly radical element of this design is the nearly total lack of taper on the bit. A Phillips screwdriver bit is virtually designed to climb out of its matching recess because of the way it tapers to a point. The walls of a torx recess are nearly perpendicular to the face of the screw. This allows for dramatically more torque to be transferred to the screw without risk if slipping. Since you want the screw to make the hole in the wood and not your screwgun bit, this will be an important benefit.Unless you are looking for it, you may miss the next feature, located just on the other side of the countersink screw head. On a standard wood screw, the angled surface is ground smooth, because it is expected you will drive a preliminary pilot hole near the same size and shape as the screw it will receive. If you drive a normal wood screw with just a screw gun and no pilot whole, the screw will sit slightly proud of the surface, because there is no room for the cone of metal. The screw is just compressing the wood out of its way much the same way as a nail would. On these Hillman brand screws, the angled surface of the head features six sharply raised ridges or nibs. As the screw is driven home, these nibs scrape out the wood to provide a matching recess so the screw can sink to even or if desired below the surface.The shaft features an aggressive thread pattern which will firmly hold your project together. Because it is finished with a protective coating reminiscent of Teflon, these screws drive in easily. That job is made even easier thanks to the self drilling tip which is the last features of this superior simple machine.It is this last feature, the self drilling tip that requires a word of warning. This item is a screw, not a miracle. The shaft of the screw is not designed to pull wood up out of the hole. Therefore, it you are driving these onto the end a a board, you will still need to drive a pilot hole. It need not be countersunk, but you can't drive a wedge into the end of a board and not expect it to split.I received nothing in return for this positive review. I rely on Amazon reviews all the time. This is my way of paying forward, and a small effort to reward a company for a job well done.

well made and easy to use. no drilling need except on board ends.

Great wood screws

They work better when you drill a pilot hole.

Very good price for a good product

Nice deck screws for the price have not broken any of them I even tried once

Quality deck screws. I’ve never had a head strip or snap, and they are sturdy enough to reuse.