5304507200 Refrigerator Freezer Door Gasket Replacement Part Compatible with Kenmore frigidaire Gibson kelvinator, Replace Door Seal 5304408631 5304507214 216522309 216522310

Fit my freezer perfectly. Wasn't very difficult to install however I would suggest that you have 2 people do it. I took pictures of before I took off the old one to make it easier to figure out which way it goes.

If you want a pretty new white gasket that doesn’t do anything to seal your freezer door. This is for you. It has the correct dimensions length and width. However it is not thick enough. After a week of giving it a chance I removed and put the old one back on. You can feel cold air pouring out all around it.

Installed easy

Very good product, and I love it, I'll see how long it lasts, works perfectly, but no instruction

Frigidaire freezer 31.5"x60" door. Easy installation. Laid it out on the sidewalk at 105 degrees to warm up. Peel back the inside of the door seal to expose the screws. Back them out a little and peel off the old seal. Start at the top working down, set/ secure the bottom, pull the slack up evenly, tighten all screws. 30-45 mins. Now the lock works now.

Installed this on an 11-year-old Crosley CFUFH17W freezer which has been located and running continuously in a non-climate-controlled environment the entire time. The seal arrived on a 110ºF afternoon already thoroughly warmed in the box. Laid it out flat on a bed to let it unkink until evening time so I could install it during relatively cooler outdoor temperature. It went in with no problems at all and only a small bit of cursing (related to 45 screws and stretching the new seal into place properly). Seals tight and now have to tug pretty firmly to get the freezer door open. Feels like it’s going to last a while too.

Gasket is so deformed from being folded up that it could never possibly seal. Even went as far as to use a heat gun to try and make the silicone malleable again but it was a waste of time. Don't bother buying from this distributor. Beware

The gasket wasn't that hard to install. It took me about 30-45 minutes. I guess it depends on your appliance. It has saved me from buying a new freezer, so I would say it is well worth the money. I no longer have ice forming in my frost free freezer.