Metal Raised T Logo Frunk Front Emblem Decal Matte Black with 3M Adhesive for Tesla Model 3 Model Y Highland Juniper (T Logo Only)

I previously was using emblem covers that honestly looked bulky and cheap but finally decided to do it right by replacing the front emblem entirely. Install process wasn’t too bad: tape around the emblem, use floss to cut through adhesive, clean with isopropyl alcohol, and apply. The emblem looks much sleeker now and seems high quality. Definitely a much better look than the stock chrome one. I’ve been through a few car washes already and the adhesive is holding up great!

These emblems are fantastic! The black look is just a simple thing to make your car a little different on the road but really catches the eye.The fact that they're metal with really strong adhesive pre-applied makes the emblems feel premium and non-flimsy, unlike some plastic ones. The placement stencil for the lettering on the back made placement and installation super easy.

Great looking logos and would be 5 stars all day if the tape was thinner. The factory emblems fit tighter to the hood and that does impact the look. The hood logo especially stands out being too thick. Installation is easy enough, take your time and prep the surface correctly and the adhesion should be fine.

I really liked this Tesla Logo, it had some height, different a bit than standard Tesla logo. The adhesive tape on the back was thicker than I would have liked and it did NOT say 3M on it. Functionally, it's a Tesla logo, but, on day 2, after sitting out in the sun for about an hour, the lower part of the "T" started releasing from the hood. I know what you are saying, you didn't clean it properly, wrong. I cleaned it very well with alcohol wipes and did not touch the area before applying the logo. Bottomline, the adhesive didn't hold, and it won't stay on the car. I've already ordered a replacement, this was a lesson learned for me, make sure, absolutely sure that it has the THIN genuine 3M automotive tape. I will remove this one with dental floss and start over.

The matte black look is super-clean and the metal fixtures look and feel top notch. Installation was simple, although it requires just a little bit of patience to get the old adhesive off (this is product-independent). [Pro tip: use “Goo Gone.]One trick for the rear letters: if your “T” logo is still on the back, you can align the template over the top of it to center the word, and then peel back one end, remove the old emblem, and then tape the template back on. I put my letters 3 inches from the bottom of that part of the trunk, although on the Model Y you can fit them below the logo if you want. The front logo and DUAL MOTOR are pretty straightforward.

Why did you pick this product vs others?:Not good had to throw away

High quality metal emblem, unlike other company plastic emblem. Look a lot better than stock chrome emblem. Customer services are top notch. Contact them with any issue, they will resolve within minutes.

Overall it’s a great looking emblem and easy to put on. I love that the TESLA letters came with a layout template. My only complaint and why I’m not giving 5 stars is that the adhesive is a light gray which you can see as the black emblem doesn’t sit flush on the paint and raises up a bit so the light gray adhesive is a bit noticeable. I’ll probably not notice it after a while but it’s slightly annoying.