Gempro2Pcs Dynamic Smoked Amber LED Side Marker Turn Signal Light Compatible with Golf4 MK4 GTI R32 Jetta Passat B5 Lupo Polo Sharan Vento Fox Amarok T5

Easy install & they look great on the mk4 golf

It wont let me upload a picture or video at the moment.But I just installed these in my MK4 GTI 337.The plastic plug with wires that goes into the light bulb socket is a little thick. They are hard to plug in, but that just means they shouldnt come apart after the lights are put on the fenders.I have mine set so the lights light up from front to back. And if you are super picky like me, there is a left and a right.Both sides have the stationary prongs towards the front of the car, with the flex tab on the door side.And there is tiny writing on the plastic covers that if they are on the correct side, they will be readable, not upside down.The lights do have a very tight fit, so I'm not sure how I'm going to take them out without breaking them, unless I take off the fender to be able to get to the flex tab to release the light.Last thing is these lights are thicker than the factory lenses, so they still out a little bit more.

Just as advertised.

The media could not be loaded. I love the way these lights look on my 2001 Golf. I like the dark look and that the light is different from anything I’ve seen around. Word of CAUTION during install though. Since I already had aftermarket lights before the wire leads were soldered so I had to strip and connect the new lights. While stripping the new wires one of the wires broke off the inside. I had to cut open the plastic body solder new wires to the board and piece everything back together. Definitely a Frankenstein job but the light works perfect. Just be careful if your gonna strip the wires, and when snapping them in place since it almost feels like it won’t fit but it snaps in and hold perfectly. I’ve had them installed for about a month now and everything still works great.

The media could not be loaded. Super simple install, literally took no more than 5 minutes. Go through the fender liner, pop out the OEM side markers, unclip the connector, plug in the new connector and pop the side marker into place! The only complaint I have, and I’m not even worried about it, is the side markers poke about 1/4”-1/2” past the fender. They don’t sit flush like the OEM side markers do. Nonetheless, I love the LED’s and even though they’re smoked, they’re actually really bright. 10/10 would recommend.

These snap in to be a tight fit. Which is way better then the old style spring clips verson. There are alot of cheaper brands out there, be careful since most other version do not work in progression or at all. The only down side is these stick out further then other on the thickness of the housing. Also can take some work plugging into the original socket. Other than thoses little things. Took 2 mins for each to be installed and make sure i have them both the same way.

Had to dremel plastic material off the connector, it is too thick to inert into connection socket. Had to dremel a notch into the tension tab in order for it to snap/lock into place. But…after mods it’s a cool light feature.

The media could not be loaded. All I can say is they look awesome on my car. These lights are very easy to install. All you need is a small flathead screwdriver covered with tape (or anything to prevent scratches) on the end to remove the old ones. It's plug and play.