🔧 Drill Your Way to Perfection!
The UK Drills 5.0mm TCT Drill Bit features a tungsten carbide tip and high-speed steel finish, making it the ideal choice for drilling through stainless steel. With a straight round shank design and compliance with DIN 338 and BS 328 standards, this drill bit is perfect for both professional tradespeople and DIY enthusiasts. Its precision engineering ensures a clean and efficient drilling experience.
| Shank Type | Straight |
| Surface Recommendation | Stainless Steel |
| Finish Type | High Speed Steel,Stainless Steel,Tungsten Carbide |
| Material Type | Carbide |
| Minimum Bore Diameter | 5 Millimetres |
| Cutting Diameter | 5 Millimetres |
| Tool Flute Type | Spiral |
| Cutting Angle String | 135 Degrees |
P**A
Tungsten Carbide with low angle cutting tip
Used to drill stainless steel and also a euro lock cylinder barrel pins. Worked very well
R**N
Tungsten carbide drill bit
Perfect made the job easy,drilled straight through hardened steel 👍😀
R**B
Good but don't press to hard.
Got the job done although the first one snapped, could have been my fault with pressing hard to make it drill through.
D**N
Great drill bit
I use to work in engineering so knew i needed a carbide tip drill to go through my steel lintels to hang my blinds ,and i wasn't disappointed it went through like butter and made the job a whole lot easier ,will definitely buy again.
H**E
Not fit for purpose
Both drill bits cobalt tips snapped off within minutes of use. I was careful with drill pressure, rotation speed and used plenty of cutting oil. I was drilling 4mm mild steel. Very disappointed. Have requested a refund.
A**R
Low quality
Bit warped while drill through 2mm light aluminium. Will not buy again
K**M
9mm
Very good at drilling through where cobalt drill bits cant, I did snap the carbide tip but it was my fault I would buy them again because they went through hardend locking nuts like butter just don't push on too hard and take your time and use cutting oil it helps very well
C**3
Fantastic performance on steel
I can honestly say I was utterly astonished !The 4mm bit I purchased drilled through treated steel 3mm thick multiple times and still goingThe drill doesn’t wander or pickupYou have to optimise speed and I used a touch of light oil and took my time
Trustpilot
2 months ago
4 days ago
