ToughBuiltTB-CT-36-M7 7 Pocket Pouch

This is a good pouch if you are planning on getting a proper belt to keep it on. I tried it just using a regular leather belt and found it pulled down on my pants too much. I am skinny so I have a boney waste. The plastic clip would dig into my side causing discomfort. I wound up selling to a co-worker and went with another brand from a big box store that offered a padded belt. The quality of this thing exceeded expatiations. Built to last and be put throught real work enviroments. I would reccomend if you are looking for a pouch that wont unravel after a couple days of use. They also offer other accessories that work with the clips as well.

Small but pretty handy to use it all day long without bothering at all. I bought two of these

This product is exactly what I needed. Comes with the “clip tech” ( belt clip ) which I just use to my normal belt. ***Note the more heavier the tools the more it will weigh on your belt by default. Upgrade to the “Clip Tech” tool belt once you have enough !The “tool belt” is a wider belt then normal belts for your pants reduces the weighed tension where you clip to belt.This bag is very durable and is the only bag I carry on me the moment I’m out the car on every job site !I watched every video I could find to see a customer who purchased the bag hoping to see how it would look with the tools I use. The only way to know is to purchase, and I’m happy !

It's much easier than carrying a bag of tools and I can fit the tools I need 90% of the time. The only problem is I've lost some bits and bit drivers on my electric screwdriver through the bottom.

Been using the ToughBuilt 7 pocket tool pouch for a few weeks now and it is great. There is more than enough pockets for what I need to carry on my side. I don't need bigger pockets on a tool pouch. They become a catch-all and then weigh a ton.The 7 pocket pouch has room for1. my snips(in a screwdriver slot)2. 9n1 screwdriver3. Two sharpes (one in a screwdriver slot other in pen slot)4. cell phone (without case. in back center pocket).5. Punchdown tool ( in front center pocket)6. mod end crimpers( held by 1 handle in screwdriver slot)7. channel locks(same slot as the punchdown tool.)8. Tape line9. Roll of black tape ( made a "T" out of stiff ceiling grid wire and looped it to the elastic that held on the ToughBuilt paper).10. And there is still a "loop" to hang butt-set off of if needed.Now I don't carry all that, all the time. But nice to know I can (and have) if needed. And easily access it all.The pouch can easily be removed when sitting.Have even forgot and left the belt clip on for about 10 hours the other day when heading home. Was a very LONG drive. The trip took 28 hours.I just wish there was special pocket for the snips. They are loose in the screwdriver slot. But overall I'm very happy with the tool.

I’m an electrician and used for 6 months now. It has held up great. Easy to take on and off for tight spots, tools fit perfectly and it is quite comfortable to wear. Highly recommend

Some of the tools I have, screw drivers, wire strippers, linemen, don't quite fit mainly because of the thickness of handle grips. Brands like Kline screw drivers (not all i use) fit perfectly.

It’s so easy to clip on and go when I get called out to work during the night highly recommended