REPTI ZOO Upgrade Reptile Heat Mat with Thermostat - 8 x 12 Inch Reptile Heating Pad with Temperature Control for 30-40 gal Tank Reptiles Amphibians Hermit Crab Snake Lizard

I just installed this on my big terrarium.We have some Cope's Gray Treefrogs in it.It is big. It measures 36" tall x 24" wide x 18" deep.This species of treefrog doesn't really need a heat source, but isopods and springtails need warmer than our room temperature is. We keep the room temp at 65 degrees during the cooler months.I installed this in the lower left side of the terrarium.It has successfully raised the temperature about 7 to 8 degrees. I have the heater set at 85 degrees and the temp is currently 74 to 75 degrees. This is up from 67 to 68 degrees before the heater.The lighting in the terrarium doesn't create any heat at all.This was the safest way to add a little heat to this terrarium. It's working out just fine.I like the fact that the adhesive is good. I also like the fact that it doesn't use a remote probe. It wouldn't be helpful for my setup.This heater wouldn't be sufficient to heat this terrarium for certain reptiles, but for my needs, it is perfect.I recommend it.

seems the "fahrenheit" temp digital read out was broken. But the C read out worked for us. We used this mat to keep our kombucha bottles warm on cold winter mornings when brewing. Successful!

Trash!!!! 🚮 returned it because the box was opened, someone clearly already returned this product but then they sent it out again??!? Wtf.It’s broken, the controller to adjust temp was broken and not working. I can’t let my sweet baby snake burn!! Why would you sell this crap!Also the quality of it seemed so cheap. It was rolled up and hard to even open up so it didn’t lay flat. There was no way to stick it. This was yet another dollar store quality product. Actually probably lower quality than the dollar store.

I like the fact that the temperature probe was built in so there's only one cord and it's all single piece, however the probe is too far away from the actual heating element... so you have to have the heating element up alot higher than what is projected under the surface area of where your reptile would actually be sitting. In other words, I had to have it set for 95° F in order for the surface temperature where my snake would be, to be at least 85° F.

We have had this reptile heat pad with regulator for over a month now and are very pleased! It works perfectly, and is easy to reset different temperatures!! Highly Recommend!!

Finally a uth with built in thermostat!

Product does not work properly. Can set temp and the sticky paper to mount it is not adequate.

This product worked perfectly at first. Now around 3 months after purchase, it has basically stopped working. Even set to 86 degrees, it is barely getting warm.