Auto Dynasty 6" Round Fog Lights+Offroad Super 4X4 Guard+Switch Compatible with Grille/Brush/Bull bar (Amber Lens Black Housing)

Works good, easy installation, and very bright

Llegan en buena condición igual ala imagen muy buena elección

Product looks great. Installation, not so great...if your not experienced. I was an automotive tech for 13 years. My advise is not a knock on the product, just a word to the wise.I received it promptly and in tact. Product worked as it should after installation.So why only a 3?1-Instructions were not included. Not even a basic schematic.2-for mounting on a bull bar, the lights must be disassembled in order to tighten down. The wiring runs through the mounting stud so you cannot tighten down the nut which is inside of the bull bar unless you disassemble the light to remove the wiring.3-several wires were too short and had to be lengthened in order to make connections.4-this product was meant to be wired into an existing circuit (so that it is turned on with either the headlights or factory fog lights or hi beams) and NOT to the battery so that the "supplied switch" turns them on. This was made obvious to me during the installation because there is not a fuse in the power wire to the switch. The kit DOES include a fuse however it is located between the battery and the relay for the secondary power to the lights. But the circuit to the switch is not protected.A little annoying for an installer but not a big deal if you're good at what you're doing. However for the inexperienced DIYer, this can be a pain, not to mention dangerous especially since there is not a schematic showing no fuse in the power wire to the switch. If you didn't know any better then you would install this completely unprotected.This is the reason for a 3 star. There should always be a basic system schematic.If you're a professional installer, quote your labor time at least 1 hour more for disassembly and wiring mods.All that said, they look and operate great!

They look just like they were advertised. A pain to install.First the nut and washer was attached. With the wires coming from lights, so then you have to get them over the wire fittings, then you better have a go thru socket set, because if not you will have to finger the nut and washer on and try to find a wench to tighten it down. This if you putting the lights on a bush bar of truck.

If you have .a bull bar on the front of your vehicle,these lights are a tough install. I clipped the wires on mine, pulled the wires through the mounting bolts, drilled a hole in the back of the light, installed a rubber grommet in the hole to protect the wires, then put silicone sealant around grommet.This made for an easier install, but I'm sure I voided the warranty,but it worked great for the installation,also note,my truck already had a wire harness from previous lights, so installation was easy, but do yourself a favor, replace the switch supplied with these lights, the one provided is poor at best.

There are no installation instructions nor a schematic...Nothing!!! The lights are poorly engineered as you have to dissemble the lights in order to install them, what should have taken me 30 mins max to install, it took about 2.5 hours. Once the lights were installed and operational, I was not impressed with the luminosity of the fixtures they are as bright as my low beams on my truck; the OEM fog lights in my truck are lot brighter... Bottom line, I would not recommend buying these lights, pay a little bit extra foe better lights.

I liked everything about this fog lights added a cool look to my dune buggy easy install $5 piece of pre drilled metal strip from Home Depot and 2 Muffler clamps from the auto store half an hour and they were in, haven't hooked up the lights yet but it's all ready to go would recommend price is okay will know better as time goes by...

I Got for a friend for Christmas I'm sure he's going to get a kick out of them and really enjoying him on his vehicle I think they're pretty damn good I'm going to get it for myself