VHT SP201 High Temperature Wrinkle Plus Paint – Black Spray Paint - 11 oz Aerosol Can

Love the paint

Really good paint only issue I had was my fault I over sprayed and have over hang wrinkle but I was able to shave down the long wrinkles to keep it smooth.

Wrinkles really good if you put the coats on thick and i used a hair dryer to heat it up worked great!

The media could not be loaded. As titled;If you do as the can says, the finish is great. Used it in red here on the intake pipe of my r53 . Holds up to engine temps. Finish is great. Just go heavy on the coats after the 1st. Learned that doing a valve cover in black . But alas that's the trick and for prep I just de greased it , then washed it of the chemical residuals, then red Scotch pad it . [Was a polished aluminum to start]Great product for many applications though.

This is the best wrinkle finish paint I've ever used. But be advised, this stuff takes FOREVER to gas off. The item I painted almost a week ago is still sitting outside, and still very fragrant. I hope to bring it inside one of these days.

Awesome paint if you have off-road wrinkle black bumpers. This works for touch ups.

It turned out great. I decided to use the painted valve cover over the original itr, mainly because I had bungs welded into it. It is brighter than an itr cover but I like it. See for yourself.I cleaned my valve cover with dawn dish soap and sink brillo pad like sponge. After it dried, I cleaned it with brake cleaner, then dawn soap again and rinsed vigorously. I let it dry for days and then taped it off. I did not use primer. I shook the can for 2 minutes. I did 3 different directional light coats as instructed, waiting 5-7 minutes inbetween. After the 3rd coat, I lightly applied heat from a heat gun evenly for 25 minutes, be patient! Pulled the tape 15 minutes later. I let it sit for days then razed bladed the letters and sanded them. Temperature in garage was around 70 F and watch out, the over spray travels far and will coat a garage floor, ask me how I know.

This paint was easy to apply and easy to achieve the retro look I desired. The directions are specific, you must read them. It requires a couple coats with a short 5 minute "flash off" dry time between. It was easy to achieve a moderately heavy coat without sags and runs, but, if you have little experience with spray paint, its a good idea to practice before tackling your precious project. A first timer will always have trouble with runs and sags. The nozzle gave me more control than the average rattle can. I give this product a thumbs up.The directions don't really cover oven curing for metal parts. I have plenty of on the job finishing experience so I used our oven to speed up the wrinkling and curing process. Open windows fans help with the paint smell, there will be some paint odor needless to say. After the freshly applied paint coat has air dried (minimum of 30 minutes), This allows the paint solvents to off-gas safely. Its ok for the paint to begin to wrinkle. Then I bake it in the oven at 150 degrees F. for approximately 45 minutes. Since it is a kitchen oven with little venting, I open the oven door briefly every 10 minutes to let remaining gasses escape. Turn the oven off to cool, do not remove the part while still hot. At this point the painted part is cured and durable enough for handling and assembly. Without oven curing you should give the finished part 24 hours before handling. Most plastic parts can't tolerate heat without warping etc.