Metal Front & Rear Portal Axle Set Upgrades Parts Compatible with WPL C14 C24 C34 C44 B14 B24 1/16 RC Car (Black)

This is A kit. It's casted well but needs cleaning (matching,sanding) always fully disassemble all the parts you get. Shims and micro bolt kit you will want. When I removed the pumpkin covers I could see the inter bearings sliding around. (Matching)

They work but you’ll need to strip them down and add loctite to every screw. I have had so many issues with the screws coming loose and the 4 wheel drive not engaging all the wheels. I wish I would’ve bought better quality axles but it was a budget setup.

The media could not be loaded. Pretty much the same design as everyone else, I wish they'd offer an open diff version for trail runners but for crawling they're fine, mine were well aligned as far as seams etc, however they had zero grease in them, I prefer what I use anyway. Still waiting on parts to complete the build but I have no regrets from what I've seen so far

GARBAGE…. Worked for about 2 minutes and now the gears aren’t engaging so the tires won’t spin. Went to get a refund and Amazon demands that I send these back, the closest ups store is 35 minutes out of my way.

These would be better if I didn’t have to do so much to them. The finish on these axles are nice. However, there are several things that I would recommend doing before installing them.1) These axles come dry, so make sure you grease them.2) Put blue loctite on the small allen screws that hold the stubs on the rear axle. If you don’t, they will back out, making the wheels wobble and likely fall off.3) Put a nut on one end of the steering / alignment rod on the front axle. It does not come with one, and it’ll spin while driving it over stuff, causing your alignment to get all wonky.4) Metal driveshafts are a must as the stock plastic WPL ones do not fit without forcing them on. Even then, they do not go all the way on.Once all of this is done, they work great. They do seem to improve the steering radius of the truck a little. If I can do half stars it would be a 3.5.

Both differential did not come lube so I used a synthetic grease and the front differential came in reverse assemble. I have to take it apart and flick it around to make it work.The steering pull link came straight so I used another from my other kit and had to bend it to make it fit and work properly.

Complete garbage don't buy and if you do buy take it completely apart and tighten and loctite every little screw on it otherwise it's going to fall apart over and over and after you take it apart once the screws strip so good luck

These look great but have gaps around the seams and will allow dirt and water in! Also, the front I received had everything installed backwards and after installing had to remove, disassemble the entire front end then reassemble to get everything to work…what a pain!!!