FrSky X8R 16CH 2.4GHz ACCST Receiver SmartPort Telemetry SBUS Port D8/D16 Mode Compatible Dual Antenna Full Range Firmware Upgradable Taranis X9D/DJT/DHT Support

Very good. And works extremely good.

I know this receiver is a little old school. It works well and has good range. I actually own two of these receivers now. I had received one with my first Taranis transmitter purchase and I've worn the crap out of that receiver but it still works well. I bought this FrSky X8R Receiver for my newest TBS Discovery drone build and it has been working very nicely for me. It's easy to bind and get setup even if you're just using PPM or SBUS connection with it. It's easy to set Failsafe on it and it gets really good range for me. I would recommend this receiver if your building a larger sized drone in like the 450-500 class.

Not directly compatible out of the box with all modes it claims. DFT/DJT/DHT/DHT-U . I think mine was DJT. You must reflash to use with the older firmware. You accomplish this using the receiver and a four to four pin flat servo cable. If it doesn't bind to transmitter, try googling the firmware flash and try that.

After many years, I finally updated my old Dynam Skytrainer from the FlySky radio to Taranis, and because it has a separate Gyro (from HobbyEagle), I used this receiver for that plane.Super easy installation; this receiver is not the smallest unit but I had plenty of space in that airplane. 90 degrees separation on the antennas (one vertical and one horizontal) ensures great reception, and I have RSSI alerts on the transmitter. The old plane is flying better than ever now with no more radio signal problems!

Este modulo no es compatrible con el DJT. Probe el bind de distintas formas y no se enlace. Tengan cuidado con este producto ya que en la descripcion dice que si es posible la conexion con DJT, sin embargo no se conecta.

This was really easy to bind with my FrSky Taranis Plus transmitter. It is also pretty small for what you get out of it. I ended up using my 3D printer to print out an antenna holder as they were not the easiest to figure out how to mount. I currently have it paired-up with a Pixhawk flight controller on a Y6B multicopter. I'll get another one of these when I build my next copter, and maybe for a rover I have planned as well.

Great receiver to add to my collection!

Shipped fast and is exactly like my other x8R. This is a great little receiver unit if you are running a drone and need a failsafe automation in the event of a lost signal. I really like the Sbus feature for running all my channels off one, simple connection. It makes for a much cleaner build with less wire mess. I have crashed the quad a few times with this receiver and it has never had any issues...seems to be built very tough.