FuXing Ring Size Adjuster for Loose Rings Invisible Transparent Silicone Guard Jewelry Tightener Resizer 6 Sizes Fit Almost Any Rings 6 Pack

The Ring Size Adjuster is EXACTLY what I needed! Initially, I didn't think this product was going to do much for me. This was one of those occasions where I hoped to be wrong, and I certainly was. I had purchased two rings, both of which were too big on me. The bulkiest of the two is my favorite, but wearing it was next to impossible. The weight of the stone and setting constantly caused this ring to shift, falling underneath my fingers. Not only was this annoying, but it was only a matter of time before the ring fell off altogether only to be lost for good. Re-sizing the ring is always an option, but I didn't want to pony up the money to have it done. I gave the Ring Size Adjuster a shot. And it WORKED. Once the Ring Size Adjuster was correctly in place, I was able to put both rings on, and experience wearing them without any worry at all. The rings sit securely in place on my fingers, with little to no slipping. Both stay exactly in place. The Ring Size Adjusters are only visible if you open your hand upside down. When the length you need is properly cut, the length of the extender will not extend past the sides of your fingers. And did I mention this? These things are comfortable! I was concerned that the extenders would irritate my skin, or that the ends would poke into me somehow. That's not an issue. In all, the Ring Size Adjuster solves the problem of rings being too small, and it does its job well. The multi-size pack ensures that you will have an adjuster to suit the width of a variety of different rings. The length given is sufficient to remedy a number of rings. For the low-price you're paying, you are going to get a lot of use. Many reviewers had difficulty putting the extenders on. I was worried that I would have the same experience. Again, my fears were unfounded. A lot of the problems that other reviewers cited were probably due to incorrect placement of the adjuster. Take your time when you apply it, and you'll see that it's really pretty easy. Just hold up the underside of the ring and compare it to the width of one of the adjusters. When you think you've selected the correct one, snip off the length of extender that you need. I arced my ring and an extender together, and snipped off an amount that would only cover the bottom. After this, just take the tip and separate it just enough to wrap it around the ring. Then take the entire extender and begin coiling it around your ring. Every once in awhile, stop, and squeeze the extender together so that it's good and tight on the ring. Keep wrapping until you get to the end. It's really pretty simple. Bottom line is: You can't go wrong with these extenders.

I have really small hands, and a size 5 ring is a too large for me. I like to wear a few cute, inexpensive rings on my ring finger and pointer fingers, and sometimes the cheaper, fashion rings (not engagement rings) just don't come any smaller than 5. This product works well to make them wearable for me. It comes with a variety of sizes (thicknesses) of coils as well as you can cut them to the length you need. I used the second smallest coil for a ring on my pointer finger and it has worked well. I won't say you can't feel it, and I do fiddle with it throughout the day because it's there, but it doesn't hurt and it keeps the ring on. It can slide around a little depending on what kind of ring you have, but that hasn't bothered me too much. Definitely worth a try if you have ring you really like that is just a little too big!

Works well to keep ring from being loose - just what I needed. Different sizes are nice to figure out what works. Two cons: The thick one rolls off just a bit and needs to be looped back on. Also, it's slippery and makes the ring spin sideways. Still worth it.

These ring size adjusters that came in multiple sizes were fantastic! It was cheap, good quality and easy to use even though there were no instructions. Very common sense, coil it around your ring band until it covers the area that you need and then cut of the excess. I was able to use one ring adjuster for 3 rings (myself and two daughters!). Previously, I was using scotch tape wound round and round the ring band until I found these ring guards. As a health care professional, I wash my hands a lot and it didn't affect the adjusters at all so far.

I bought this product because I'm losing weight and not ready to resize my ring. It's easy to customize the ring guard to get just the right fit. While I can feel its presence when I'm driving or lifting weights, it's easy enough to spin the guard out of the way to resolve that issue. It's a bit of an annoyance when putting lotion on, as things do get caught in the guard - but it rinses out very well in normal hand washing. Overall, it's a great product and far more comfortable than my previous metal ring guard.

Snips to desired length easily. Spin wrap around the part of the ring that lays closest to your palm; try to avoid going too much between the fingers. Doesn’t seem to yellow as time goes by. The only thing I find is that bar soap builds as you’re washing, but it does clear off with rinsing. The lengths of each strip can take care of sizing several rings.

Wish I had known about these years ago. My wife uses adhesive tape to make loose rings fit. We tried this product. Installed easily. The comfort is good. The rings are no longer loose and we have plenty left over for friends. Great product and value.

The adjusters are designed for you to cut down to size. Sounds like a great idea, except that bc they are springs that wrap around the wrong and arent secured to the ring itself, they unwind and start to slide off as you take the ring off. Not effective and not worth the couple dollars spent. I took my rings to the jeweler instead, they attached an adjuster and completed the job the right way.