Hopkins Towing Solutions 56200 Plug-In Simple Towed Vehicle Wiring Kit

This kit has everything you need for an install on a jeep. Expect to take a few hours to do the routing of the wires- A Saturday should be put aside to do this project. I highly recommend a pre-packaged kit like this specific for your vehicle that just plugs into the existing wiring harness - it significantly helps the installation. Jeeps are easy to work on and access, just take a little time to figure out the best routing and have a bunch of zip ties available and you should have no problem. This comes with all the parts you need to install it in the base configuration to allow the fundamental functionality of brake lights and turn lights. I added additional wiring and fasteners in order to hook up the 12 V charging line to enable me to provide power for recharging the battery of the toad as well as power from the battery to the blue ox supplemental brake at the drivers position. A key thing to doing this install is having some sort of snake to allow you to snake the wires through various members of the frame. I also found the mechanic type long hemostats that I have in my toolbox to be helpful at various points. Straight forward installation if you plan ahead a little bit. My jeep has a towing package installed from the factory which did not cause a problem. I did have to call product support which was very helpful to help track down a grounding issue that was easy to resolve.

If it says Hopkins then you know it’s good.

Simple install. Plug and play. Made to last. At a great price.

It now connects my coach to my toad.

I only thing about this kit that I wasn't pleased with, is it still needed a brake light relay! Other that that, great kit, easy instructions....

Really easy to install {have a hoist} works Great !

Worked great. It was exactly what I needed.

Excellent, simple product! I've previously wired a tow vehicle with lighting and spent nearly a day pulling wires and installing auxiliary lights. I saw this product for my new tow vehicle and thought I'd give it a try. 45 minutes...that's it! Super simple installation with the biggest challenge in routing the wiring up front to the pull vehicle connector, which only took about 15 minutes. Highly recommend this. You should have a modest level of mechanical skill to install. A shop should be able to do it in under an hour. Installed on a 2015 Jeep Wrangler

Watched videos on the product seemed easy so i tried it was done in my driveway in less than 1/2 hr

Déjà installé et fontionne très bien

Nice product. Lots of wire. I removed the 4 pin end and used a 6 pin because I needed another lead leaving the wrangler to the RV. Would recommend. Great to have the diodes to isolate the towing vehicle. Be advised if you are towing the wrangler and using a readybrake or other mechanical brake system you need to isolate the wranglers break lights with a relay otherwise when the signal lights are activated on RV the brake pedal in the wrangler will over ride that turn signal with a solid brake light.

Easy to install, works great

Plug n play installation