Nilight 10 Pack SPDT 5PIN Electrical Relays 12V 30/40 Amp 5-Pin Switch Relay for Automotive Car Truck Marine Boat

Used it to replace the ones on my Ford f250, worse great so far, tested them, all. All tested good. Been using for over three weeks the ones I did install. I took off the metal piece piece that sticks up, isn't difficult to take off. I like the metal piece in case I need to install an extra part, and just bolt it to side of engine wall compartment. I give it a thumbs up.

I purchased these to install on my Kawasaki klx230 during my led turn signal upgrade. I’ll say that my first impression was that they’re super lightweight feeling. If they had put some weights in the flasher relay unit to make it feel heavy I probably would have accepted these as high quality.. nothing about these seem low quality mind you, just super light weight. Probably a plus if you’re looking to save weight.. After I installed all the turn signals/ brake/ running lights I tried the signals and yup.. they did the hyper flash, stutter and then kinda try and work halfway. So I installed one of these flasher relays and my signals were better, but they still weren’t blinking and acting like they should. A bit frustrated, I decided that they probably sent 4 of these because -quality control- So I grabbed another and installed it. Same issue. Different than before install but not acting like they should. Ugh… frustrating to not have the solution I attempted to pre-plan for. Just before giving up and going a different direction I decided to try and run the bike and test everything as I attempted to adjust the blink rate thinking maybe it just doesn’t like the pre set blink rate. My turn signals are sequential, plus there’s a running light on the front signals and the rear is a signal with a 10 blink flashing brake light to add to my current brake light. Maybe those extra functions confuse the whole system.. But after I attempted to adjust the blink rate everything just seemed to come into proper function. Was it my adjustment that got everything in line and working? Or is this a fluke that I’ll find later didn’t work? So far they work after my initial adjustments so of course time will tell.. although I don’t put many miles on the bike so that may take awhile. They work! … I think? If they don’t then it’s likely I have to do something different since my signals have extra functions?…

Great value, especially when the local parts stores want to charge the same price for one. They all come from the same place so I am thankful that Nilight has such good marketing skills.

I planned to use these to blink an LED that I'm using for a car alarm setup rather than using them to actuate a blinker on the car. I tested them and they worked the way I wanted them to, but I didn't like the blink rate for my project... too fast. The adjustability wasn't quite good enough to match what I wanted, so I'm using a different solution. They definitely work as a blinker relay and would blink LED lights when hooked up in line. The speed is perfect for a car blinker.

Had a couple of older harnesses that wasn't working so I ordered these and they worked very well on someone else's harness. They seem to be compatible to other harnesses. I now have spares for my harnesses and those others. Good company and products.

Good buy.

Fixed the issue

Perfect

ممتاز جدا

ليس كما في الوصف

Para adaptaciones buenos resultados

Excelente calidad/ precio, son los mejores que he visto por precio. Solo espero que su calidad si sea muy buena o al menos fiable, ya que estoy haciendo una instalación de eleva vidrios eléctricos.

La calidad es muy buena para el precio. Las e llegado a ocupar para maquinaria pesada y funcionan sin problemas. Son demasiado buenos.