VVIVID XPO Gunmetal Grey Brushed 5 Feet x 1 Foot Car Wrap Vinyl Roll with Air Release Technology

I got this to cover my Mazda's piano black center console that was both a dust and fingerprint magnet. I LOVE the result. Looks professional and factory/OEM and I'm very happy with the result. See the pics for my results.One issue is that this is designed for car body wraps with large surfaces. With a console wrap like mine, although it was easy to get a wrinkle-free cover over tight curves and corners, it was more difficult to get good adhesion on the overwrapped edges. I would suggest you use adhesion promoter wipes if you consider doing something similar.

Very pleased with quality and price! Used for my car interior. As a side note: Make sure to look at the direction a pattern runs on the roll! Fortunately for me, even though the linear pattern ran opposite on the roll than the direction I needed for application in my car, the width allowed me to turn it... However, if the area in my car had of been a few inches longer, then the roll width would’ve been too short & that would’ve left me with two options; 1). run pattern in opposite direction of the other pattern already existing in the car or 2). return product. (Just a little tip before you buy any vinyl wrap product).

I've installed this product before. Couple years ago and it stuck great. Had some left over it was two years old or so it was sticking. Ordered some new. it's not sticking. They likely are still selling the same lot they put on rolls years ago. If you're not putting it on a solid surface without any curves then stop. I barely handled this and had clean hands. Have used it before. I know how to handle it. Very annoyed. They need to remove all of this old product from logistics.

Well we were given a very nice white freezer by my wife's parents that was headed for the garage where we wanted to put it until realizing we didn't have the room. This being the case we decided to put it in the kitchen...only problem was all of our appliances are have been upgraded to stainless steel.At that moment God gave me the idea to buy a metalic vehicle wrap off Amazon and wrap it. OF COURSE Amazon had a selection of them.This one in particular well...you be the judge. I have attached some photos of the once white freezer and please keep in mind this was my first time ever installing a vehicle wrap.Note: For any other first timers, recommend installing outdoors as the self adhesive emits a strong odor while some may enjoy...use outdoors.

Harder to adhere on edges and corners than the 3M wrap I'm used to. I have edges peeling already after a week. I do like the color and texture of the wrap, just wished it adhered better. It would not be a problem if you were able to pull the wrap behind the edges, but for my use case on wood trim on a door, the wood trim could not be removed from the door without breaking the melted plastic that holds it together. So I did the tuck and cut method.

This vinyl has vertical (or horizontal textured lines depending on how you’re looking at it). I’ll still use it but would’ve been nice to know before ordering. I’m covering a small chrome area, but just be aware…

Not the best wrap I have worked with, but not the worst either. People you have to prep your surface. Alcohol prep spray or just a quick wipe down of the piece u wanna cover. Apply and then HEAT it to activate the super sticky adhesive. I had zero problems. And I wrapped 2 door trims. Dash trim. Console piece. And the over head light in another car. And still had a 12x18" left over. Take your time. Sharp razor knife! Measure 2x cut once. Then heat with hair dryer or heat gun. Then wipe down with micro fiber to make it's all stuck in place. Should be good to go. Pics below or above :)

I know this says its for cars, but I used it to wrap one side of my fridge. It was only good for one side but it matches my kitchen and you will need help for this to assemble it.