Mighty Mite HD-R MotherBucker High Output Alnico 5 Humbucker Bridge Pickup, Zebra

First the direct; These are incredible pickups. I replaced some poor ones on a chibson (2 tone, 2 vol) with these, and wow! I went from low output to WTF! And that is a good thing. Very loud, high output, clear with the ability to distort without compromise. I would and will definitely buy these again. The only thing is there are no wiring instructions that come with it. The mighty mite website had a diagram without instructions. I found a post on line which I tried to confirm with a multimeter and could not, but turned out these instructions were perfect. 22ohm pickup; solder red and blue together, tape off. This puts upper and lower pickups in series. Bare and white are ground, solder together and to back of pot. This makes black hot. The 17ohm pickup I soldered red and blue together, tape off. Black and ground are ground with white hot. Why are they this way? Maybe makes sense at MM. Follow any instructions including mine at your own risk. BUT once this was done, WOW, worked for me.