High Glossy Wood Grain Vinyl Wrap Sticker Decal Car Internal Wraps Self Adhesive DIY Film, Waterproof Wrap Roll Without Bubble, 100x 40cm/39.4x15.7in (Yellowish-Brown)

I bought this to match a missing trim piece in a 2010 Mercedes E350. Known problem where the door trim strip falls off. I bought the car and the trim was missing. Purchased this roll of contact trim and it matched perfectly. It was easy to work with, not flimsy. Stuck properly and I was able to trim it with an exacto knife. Time will tell if the summer heat will affect it, but I did clean the surface with rubbing alcohol first, so I had a proper surface for this trim. I have plenty left over in case it fails, but for now it looks like a factory piece. BTW, Mercedes wants over $300 for this trim and it's very involved with taking of the door panel and fitting the new piece. All that was avoided using this product. Had it done in 20 minutes.

Not as easy as some to work with but looks good.

I had never wrapped anything except a present - and not very well. I had no prior training or knowledge of vinyl wrapping. This was used to cover plastic panels on the dashboard of my car. This material was thick and strong. Backing was very sticky. Looked really great. Used a low heat gun (120 C) on edges, curves, rounded corners and contours to get a smooth, wrinkle free surface. Even screw holes came out great using an ink pen point and pencil erasure to shape. I was amazed at how easy it was to work once I learned how to cut for holes and other openings. Don't over cut or cut flush at first. Heat, stretch and fold to inside. Quality material. Withstands heat without bubbling. Biggest issue was to have and keep a clean, smooth substrate. Any dirt or chips will show in your final work. CLEAN, CLEAN is the key. Did have a few bubbles develop. Poked with a needle, heated and smoothed OK. Used single edge razor blade, old credit card with gauze pad on edge and fingers. No special tools. IMHO, surface was too glossy - sprayed with clear satin. Much better. Very impressed.

this product looks great but it has a stiff paper backer and not much stretch,i could not use iyt to wrap the shifter bezel I was planning on

Does not stick. Looks okay in the roll but doesn’t stick. Cleaned with adhering surface with denatured alcohol to promote adhesion and still peeled up within a week.

Fairly easy to apply. Works best when using a heat gun and a new exacto knife for cutting. Large sections can be done in multiple pieces, seams blend easily. Final look is very profesdional and elegant.

Tears too easily. Poor adhesion. Product looked great on the roll, but didn’t apply well at all.

Extremely easy to use even as an amateur