Imperial Tool 275FS 45 Degree Flaring and Swaging Kit for 1/8" to 2/4" O.D. Tubing

Grandson love these tools ty

They look almost identical to the USA made imperial but clearly not. No bevel for the flare on the 1/4 inch. The bevels don't meet all the way around, and the 1/8 inch slot doesn't look round, almost oval shaped. I'll be returning for a refund and I'll find the correct made elsewhere.

I bought this because I needed a good swage kit. I don't like using swage punches. I have a really nice hilmor orbital flare kit but it doesn't come with the swaging capability so I bought this. Overall this imperial does the job it needs to do. I have only used it on 3/8 copper so far and I noticed that when I try to fit the pieces together it is pretty tight. I have used other swage kits that swage a little bigger and not so tight, but this is ok. I find it hard to clamp my piece without damaging the outside too much. I'm not a big fan of the way the clamp is set up but it works pretty good in the end. This imperial does what it is supposed to do and I can't complain too much about that. I was debating this over the Bacharach swage kit and I wish I would have gotten that one instead. I have used the Bacharach before and I like it better. As far as flaring goes, it is no where near my hilmor for flaring. I strictly neeeded this for swaging and I would much rather flare than swage anyway. If you don't want to break the bank this will perform your swaging needs however I think there are better ones out there

I really just needed this for some 3/8" copper repairs in my RV, and it did the trick perfectly. I had purchased a cheap brand first because it had relatively decent reviews. But it scraped up my tubing, wouldn't clamp down fully even then, and created an oversized swage with a gap I was pretty sure solder wouldn't be able to fill properly. Sent that back and picked this one up, and I noticed right away the increased weight between the two. The vice is much smoother and of higher quality material, didn't crimp my tubing excessively, and performed a very snug fitting swage. I would have probably preferred a tiny bit more wiggle room, but once the copper is sanded, it'll probably be perfectly fine (soldering is on tomorrow's list). I love that it's made in the USA and still cheaper than the higher end brands, but seems well made and in good tolerances. EDIT: Finished soldering and flaring 2 of the lines for a flare nut, tightened up, leak checked, and I'm in business again.

Gran desilusión, en las fotos publicadas dicen que es fabricación USA, lo que me llegó es imperial pero es de fabricación Tailandia

知り合いが写真と同じもの。ケースに入っている配置、USA製というのが同じなので、購入したが、写真と違うものが届いた。評価にも値しない。