Burner Tube for Viking Appliance Oven Burner EVGIC305 VGIC365 VGRC605 VGSS480 Viking Range Parts, PB050012, 2-Pack Pb050009 Stainless Steel Gas Replacement Parts

Direct fit. Replaced two mismatched burners which both had corroded in the area of the igniter. Range is back to cooking consistently with no hotspots.

This got my oven back in action. They fit perfectly.

Had to do a little work to muscle them into place. They work, but just not as snug as the OEM ones, but for a fraction of the costs, I'd use these again.

Just as good as Viking and MUCH LESS EXPENSIVE

The item I circled in the photo is important because their purpose is to make sure when it's installed that it's in the right place and properly secured. But when they arrived that piece did not exist on my burner tubes .Unfortunately I didn't have the luxury of returning them and ordering new ones because they were for my customer. So I did my best placing them correctly and securing them the best I could. Let's hope the oven doesn't blow up!New update: four days after I installed the parts my customers called me and asked me to come look at the range I had just repaired for them. Well as a result of the burner tubes being defective and missing the peace that properly secures them in place, they fell out of place at some point and as a result the oven filled up with gas while they were cooking something, and once the gas hit the igniter it blew the oven door right off the range and inevitably blew the burner tubes into pieces. Luckily nobody was in the kitchen standing in front of it or they would have been seriously hurt. Needless to say they now need to replace their $4,000 range that I had just repaired the defective parts I was sent.

The burner tubes worked exactly as expected and the range works well now. A very hot oven!

Three things to be aware of when considering purchasing these after market burners.First, the material is actually 3-4 % thinner than the OEM which won't make much difference on it's lifetime.Second, there are screens in the air mixing aperture: made no declarable difference, no adjustment was necessary.Lastly and the most important is the location of the pins that are engaged to the mounting bracket.They are too high on the tube to properly position the burner tube so that it is horizontal.My quick solution was to bend the bracket up to compensate for the difference.Given the price difference I would have given five stars had the pin been proper locatedI would note that I am tired of replacing these burner tubes. They suffer because hot surface igniter location and burner design. You can thank the goverment and environmentalists for forcing this on all of us.I am going to take my old burner tubes and Tig weld an actual piece of rolled stainless over the damaged section and re drill the holes. Wish I had done it 20 years ago.

I am always very skeptical of reproduction parts and usually go for OEM parts. However I decided to give these a go due to the huge price different from Viking's OEM parts. They fit perfectly and worked just fine. No discernible difference from the originals.