AsiaHorse FS-9002 Pro 120mm RGB Case Fan, 26 LED ARGB and Double LED Lingting Loops, 800-1800rpm Pwm Case Fan with 5V PWM Motherboard Sync/Analog Controller (6 Pack, White)

After owning Asiahorse computer fans for over a year, I can confidently say that they've been a valuable addition to my setup. The lighting effects continue to impress, creating an eye-catching display that adds a dynamic element to my workspace. The ability to control fan speeds remains a practical feature, allowing me to adjust cooling based on varying demands while maintaining a quiet environment. One of the standout aspects of these fans is their affordability – their low cost is truly a pleasant surprise given the quality and features they offer. While the performance has been decent and consistent throughout the year, effectively keeping my system's temperatures under control, it's their sleek modern design that has truly stood the test of time. They seamlessly blend into my setup and have become an integral part of my aesthetic. In summary, after a year of use, Asiahorse computer fans continue to shine with their impressive lighting effects, customizable fan speeds, budget-friendly price, acceptable performance, and sleek modern design. If you're looking for a long-lasting solution that balances style and function without breaking the bank, these fans are worth considering.

This is my 3rd set of Asiahorse 120mm fans. So that's a total of about 20 individual fans I've owned from them. Out of that 20 fans over the course of about 7-8 years, only 3 have either started getting noisy and I swapped them out, or the LEDs went haywire and were also replaced. Compared to about 10 Corsair I've also owned, thats a far less percentage of failure. Half of my Corsair fans have gotten noisy and usually within the first year. Just goes to show that spending more doesn't always mean better quality. These Asiahorse ones are on the low end of static pressure so you'll need to run them on a higher rpm for watercooling. Even so, I would not recommend these for radiator use unless you can fit a push/pull config. I have a full custom waterloop and have used just 3 on a 360mm radiator with below average results. I've also done 6 fans in a push/pull config and then you can get away with it. Temps just run a little warmer than ideal with only 3. Sure, there are better options but the cost goes up for high static pressure fans. And even less options if you want high a static pressure with aRGB and sync. These do have full rgb sync with your motherboard and PWM control. You basically get all the features of much more expensive fans and in my experience owning many of them, they seem to last just as long if not longer than much more expensive fans. This latest model compared to my last set feel much beefier. They don't feel cheap at all. I highly recommend these before you just dump money in to name-brand fans. Asiahorse has clearly put effort into increasing the quality of their fans over the years. So for more common systems without custom water cooling, these fans are a great option. I'm not going to knock off stars because my use case is pretty uncommon and it was more of an experiment to see if they would push enough air through my radiator cooling both the CPU and GPU. Yes and no.. My current build doesn't have room for a push/pull setup. These are still great though and I'll just keep them around for another rig later. Definitely recommend these.

I purchased the AsiaHorse FS-9002 Pro 120MM RGB case fan 5-pack. I was initially very satisfied with the fans. They were easy to install during my build and worked great. The colors are vibrant and bright. However, I quickly learned that the fan controller would not remain in "PWM" mode after my computer entered and exited sleep mode. No matter what I did, even after getting tips from customer support, they would not stay in PWM mode after sleep/wake cycle. However, customer support (only available via email) said they would send me a replacement controller. What showed up was an entire new package with fans and everything. So I replaced the controller, and now it works as expected and it stays in PWM mode even when computer sleeps/wakes. This is great service. And now I have 5 extra fans in case some go bad over time. It's been 2 months now, and everything is still working great. I can't speak about color sync with motherboard as I only tested it with MSI Mystic Light, it worked, but I went back to using the remote control for color selections (it's just easier). Note: The remote control that came in the two packages I received are of the type "B", which has a dedicated PWM button. The remote works well, but it is confusing because all the tips and info I found online for these fans referenced the type "A" remote control with a white circle button, which type "B" remote doesn't have. Overall, very satisfied. EDIT (12/13/23): The new controller's PWM mode only worked for about 3 weeks, and then it stopped. Now I have to manually put it into PWM mode every time computer wakes from sleep, just like before. So I would take a star off for that. Now I am a little reluctant to recommend these fans. They work well otherwise, but I think they are now just mediocre value, instead of a great value.

I was building a white out computer, so I needed some white fans. I ended up settling on these as I really liked the look and cost. The fans them self where what you would expect, they mounted easily, they were absolutely white, and they wiring was well done. My only complaint would be the fan controller. It's super cheap and feels flimsy, it has no magnets just double sided tape (come on it even has slots for magnets) it didn't install easy enough. it requires sata for power, and then you can connect to PWM and RGB on your board (or don't and you can control with the included controller) I didn't play around with the controller, I only used it to set my fans to PWM and RGB synch on my motherboard. Which I had no issues with. The fans are not whisper quiet, but they are comparable to other companies fans that have a much higher price point. My advice if you want this to work all off of your motherboard is... Read the instructions! You need to press the "w" button X amount of times to turn on PWM from the motherboard, and you need to press "power" very quickly twice to turn on RGB synch from motherboard. If you don't do this you'll have to use the remote. Overall once they were in and I had them switched to my MB I had no issues. Armory crate allowed me to adjust their colors easily. (Disclaimer, the fans use a proprietary connector that will only work with the included hub)

These fans are stunning and they are super quiet and smooth. There is no shuttering noises or any for that matter when the power is turned on. The installation was very simple and easy and the included remote even works great (even with my skepticism). The only thing that I would have liked was to be able select specific color combinations with some of the modes. Each mode runs through programed colors and the only adjustment that can be made is the speed and brightness. A reverse blade option would be really nice for meeting the needs of any case set up. It would be nice to not have the backs of the fans facing out. Over all I am very pleased with these fans, especially for the price and they look awesome!

im too lazy to take a photo but the materiel and quality of these fans is fantastic for the price if you say each fan is about 10 12$ bucks they dont feel cheap or poor they keep my pc at the perfect temperature and i even got a pack of 9 so i had extras in case any mess up so i have spares i can use if i really need to i had fans before that were 20$ a fan and i only got 3 on top of the fans i already had in my case and they were nowhere near as good quality the noise is also nice and quiet i dont even notice them running RGB led lights are really nice as well the colors dont feel weak and i love the control i have over them definitely reccomend these for anyone to have in their build unless you wanted something like ARGB these fans are perfect for anyone needing some air cooling

Hello everyone i will try and update this as these fans are used longer. But with that said so far the fans are amazing. I was hesitant at first because of the oil leaking but so far they are good. ive had them for a couple days now and no leakage. If something does change in the future i will update. The only problem i had was wiring it all but after i figured out how to do the wiring it was alright. And for the hub it comes with 2 sata power cables. 1 for each side of the hub. So its not the hub being broke and only needing another power cable. Thank you for reading and have a good day :). Update 2 weeks later- hello i have had no leakage problems yet and the rgb fans still run well. Also use signal rgb if you want to get the most out of these fans they are amazing. Just make sure you dont have any other rgb software downloaded if yoy do get signal rgb. Yet another update: these fans are still working and I'll take these bad boys over any other fan any day. Why do I need 13 cables to plug in 5 fans? Well these bad boys do it better and look great while doing so. Buy them.

Asiahorse nailed it this time. I was at first reluctant to get this kit, but then, i decided i would, and every bit of concern went away when they arrived. They are beautiful, absolutely gorgeous, they are quite silent and they are amazingly easy to install. At first i was shocked because the fans didnt have the common 2 wires all the others have, but a single 6 pin connection i hadnt seen before, so they made me use the included 10 fans rgb control, but after a while, i found out it was actually great, and its functionality is flawless. RGB Can be set by the controller or by the board's software, and it was very easy to use. And the best, they make my PC look like a million dollars. I recommend this fans to anyone.