CURT 55534 Vehicle-Side Custom 4-Pin Trailer Wiring Harness, Fits Select Chrysler 300, Dodge Charger, Challenger, Black

Got this for my 07 Charger, installed in 10 minutes, no cutting wires, drops out the hole for the license plate light, clean. And... I got a "used" one for only 7 bucks!, Looks brand new except for the packaging. Just what I needed. Very satisfied, would recommend

Fits 09 dodge charger rt. Plug and play. There's a lot of extra harness i shortened. I used conduit/ convoluted tubing to run over the wires and made it nice even though only i will see it! But i know the chances of a wire chafing through is slim to none now. They give you a screw to use as a ground anchor for the ground strap... why? Throw that out, go directly to battery ground because the battery is right there in the trunk! If you don't like going directly to battery ground, there's also a ground stud near the rear fuse box next to the battery with a nut already on it. Why put a hole in the trunk if you don't have to? Smarter not harder! I like the harness, id recommend

Installation was very simple once you figure out how to undo the electrical connector on the tail lights. This particular harness just bundles the extra wire in the trunk, and when you are using it, hangs out of the trunk (with the trunk lid shut down on the wire). To me, that's a little tacky but nothing is stopping you from drilling a hole, cutting the plug off and soldering it back together to have it hang down by the receiver.

perfect fit.....my grandma could install this in less than 5 minuets.

Absolutely the easiest wire harness install that I have ever done. This is literally a plug n' play setup. Overall, it took about 15 minutes to get it installed and setup.