VLAND Taillights Fit for Mitsubishi Lancer EVO X 9th Gen 2008-2020, with Sequential Turn Signal, Smoked

Faros simplemte increibles pero para su set esperaba que traerán un set de luces

Awesome lights ..super bright ..one of the lights had a crack in it when I put it on but the return and new returned ones really impressed me very greatful ..one advice for anyone installing these ..keep the 194 bulbs in the corner lights or you will get a light flicker and the parking lights / tail lights won't come on ...not a light issue it's a car safety issue

It’s a decent unit assembly. Took a small amount of time to really understand how to connect properly but no more than 30 mins if you follow the wiring of the diagram they gave you.

The media could not be loaded. I had a problem with the reverse lights but after talking with vland and everything they helped me not just to fix the problem with a defective light but sent me a brand new set. They are amazing lights and I love the customer service

Liked the look, install went pretty good but instructions are just a somewhat blurry picture.There are 4 connectors that fit in the OEM bulb sockets after you remove the bulbs then 2 cable sets- they are 3 20awg wires in each set with a connector on each end... 1 goes from the hatch lid to the left outer light and 1 wire that goes between the 2 lights on the hatch lid. Both cable sets just barely fit, adding about 150mm- 6 inches to the wires would make the install much better. I used small wire ties to follow the OEM set up.Running the wire/cable through the rubber flex tube I used a piece of mechanics wire and ran it through then hooked it to the wire set and with some silicone spray it pulled right through. Then unwrap the electric tape on the grommet at the body for the left light- use a pencil or something to open up the grommet then pull the wire set through there also and connect.There is a resistor- mounted on a small pc board and some 3M tape. I mounted it on the inner part of hatch lid so it is out of the way- you get one chance to stick it so make sure you have the wires in place before you press it down.You will not use the one taillight bulb on each side so just disconnect it and I wrapped it with a bit of electric tape and wire tied them up also.100% upgrade from the original light and looks great.

Love how sporty they look

The instructions sheet is not very helpful. I had to go on youtube for help. I finally managed to wire it, but the passenger rear, outside light has issues. The stop lights often stop working or the red band stayed on faintly after the car ignition was off and so were the highbeams. It is surprising as that segment does not require any fancy wiring, only plugging in the connections. the rest of it seems in good order.

Lucen super bien estos faros traseros y de buena calidad.