LED Light Bar 10 inch - 4WDKING Screwless 50W IP69K Waterproof Off-Road Combo LED Work Light Super Bright Truck Driving Fog Lamp Fit for Ford F150 Polaris RZR Jeep Wrangler

明るさは十分です。耐久性はこれから。

Llego antes de tiempo de muy buena calidad funciona correctamente fue una excelente compra

First test with the light bar after hooking it up concludes that it is the bees knees! I’ve so far only purchased “cheap” light bars here on Amazon and have always been pleased but this one just seems a little different! Out of the box it looks well made and after installing it seems to light up like If it’s well made to! The spot/flood combo is out of this world, haven’t seen a cheap light bar like it yet! Easily out brightens all my light bars and it’s the smallest one..!!

Amazing design ideal, NO SCREW! First of all, when I first saw this light bar, I was deeply attracted by their design ideas. Without screw design, the waterproof performance will not be disappointing. I spent a great deal of time researching different lights from all the manufactures. Many of these lights, from brand names like Rigid, Bulldog and KC, cost hundreds of dollars (one of the Rigid 10" lights here on Amazon sells for over $320). I fully understand the mind frame of buying the best. I usually take that approach as well but I really have a hard time in justifying that much money for something that I won't be using all the time. Through my research, I firmly believe that every led chip of this light is from CREE, it is so bright. The entire road is lit up in a bright white light including both shoulders of the road as well as any trees overhanging. The light is thrown down the road quite a bit - further than one can out-drive in usual driving. The waterproof is the highest level I have used so far, as they advertised IP69K and No Screw Design. Due to the inside of the light bar is not vacuum, there will be a small amount of mist when the heat is alternating, but after about an hour, the mist passes through the side breather drained out quickly, which was impossible for the light bar I used before. The waterproof of the previously used light bar is not as good as the one they advertised. Every time leaking water is a very headache. Cost/benefit, this is a great led light bar.

OK, well made and designed. Very easy to mount to my Front Runner rack. Looks good with the low profile. Throws a really nice spot beam, with just the right amount of flood. Nice white light. So two minor issues. 1. Packaging the assembly hardware. These were not in a bag, but loose in the box, within a portion of the packaging. So upon opening the box, these fall out and it is hunt and seek time. 2. The main wires from the fixture is enclosed in a very heavy duty rubber wrap. Normally that would be a good thing. Except, the insulation on each of the enclosed wires is very thin and just substandard. It is almost impossible to cut the hard rubber wrap that is around these wires without damaging the wire insulation. I always solder wires and use a heat shrink. The exposure amount of wires was too short to do this. Trying to cut the heavy rubber wrap and get to more wire was not easy actually very frustrating, and I still felt I needed to use liquid wire insulation around the wires just to play it safe.