Ryanstar Throttle Cable Bracket 4150 4160 Series Throttle Brackets Billet Adjustable Aluminum Black

Very satisfied. Would purchase again. For me I used a separate bracket from previous set-up for the kick down cable. I also switched the Philips head screws for bolts. (6mm I believe. Way easier to do adjustments) I also notched out my throttle lever for the bracket that the springs attach to. It allowed the springs not to be pulled upward at full throttle. My carb is an FST (1st generation) which is built very similar to Holley carbs so my modifications may not be yours. I also did not use the spacers on the carb studs to raise it up. I didn't figure out what the spacers could have been used for until I was done. They may have eliminated the need for me to notch out the throttle lever. No instructions were included. Live and learn. Overall I'm happy with this setup. ✌️🇺🇸

Works Great! Had to cut a slot in one end for the throttle cable to go through so I didn't have to change cable end. Seems well built and easy to assemble.

Looks great. Seems to be made very well. Good buy for the money.

Got this for a sbc350 with an edelbrock carb. It does work with a little modification. Notched a section about an inch long for the linkage to clear and it worked perfectly

Good looking and good quality excellent value

The bracket is of good quality and fits well

Works perfectly.

Fits perfect and is exactly what I needed to solve my problem with the accelerator.