StarTechcom 12in Molex LP4 Power Extension Cable M/F - 4 pin Molex Power Connector - 4 pin Power Extension Cable - LP4 Power Cable (LP4POWEXT12)

Works like it should.

I made a custom laptop stand using computer case fans with molex connections and needed a "sacrificial" molex cable to cut up and splice onto an on/off switch. Since I'm only powering case fans, it only needed two of the four wires, so I pulled out the two I didn't need (which is why there are only two wires in the my attached pictures), and soldered it all up. My previous molex cable was loose so the male end would just fall out if you breathed on it. The female end of this molex cable holds onto the male connector properly. I mean, there's not much to say - it's a molex cable and it delivers power.

It's a molex cable. Works fine! What more could you want?Well, one complaint is that the pins inside the plastic connector housing wobble around a bit, since they're crimped to the wires and the plastic housing is sort of just slipped onto them. This is electrically and mechanically a very sound way of making such a cable (better than injection molding the whole thing), but it does mean its sometimes difficult to plug the cable in because the pins keep shifting out of alignment as you grab the cable.

Simple and useful. I actually used this to splice in a set of 12v LED lights intended for a motorcycle that I'm using for my PC.

A great price for a part that is getting increasingly hard to find. I had previously purchased two like this on Ebay and both of them failed due to crappy soldering. This has been working fine in the computer in which I installed it.

Great little power extension cable.

New usb 3.0 pci. Needed power and existing in the case was too short. The male pins were little loose but no problem aligning. I am adding 3.0 card to another desktop, and think this may be too short.

This item works great and I was able to connect to an IDE hard drive that was far away from connector on power adapter.