SennheiserProfessional e 609 Silver Super-Cardioid Instrument Microphone,Wired, Wireless

Excelente producto, microfono ideal para el vivo

Very nice

This thing is just a DREAM for micing guitar amps, especially "problematic" cabs. My main amp (Peavey Delta Blues) uses a 15" speaker. Trying to mic it with an SM-57 or similar is always a compromise of what kind of coloration I'm willing to accept. Hours of recording time and fiddling with placement did eventually allow me to discover a sweet spot. But even then, trying to place such a tiny capsule on a speaker larger than 10" never gets me close to the natural sound of the amp. Something is always hyped or missing. It's always a hunt for the least bad placement. If you're reading this, you're probably familiar with what I'm describing.The e609 is the opposite of that situation. You can just about throw it in the general direction of an amp and get a decent sound. Slap it right up against the grill, halfway between the edge of the dust cap and edge of the speaker cone and you're set. Use a stand or hang it over the cab. The thing is just remarkably un-picky. It's very easy to use to get a relatively transparent representation of what the amp actually sounds like with minimal fuss.A couple things to note:It's light. I dig it, especially since it spends a lot of time dangling from a mic cable. More weight would probably be bad.It is a little on the bright side, but nothing unreasonable or difficult to manage.The housing around the grill is plastic. Seems sturdy enough, but maybe don't use it as a hammer.The included mic clip is SUPER TIGHT. I suspect this is among the reasons you always find 609s hanging from a cable, even if an extra stand is available.

This is such a great guitar amp mic. Easy to use, just drape it over the front of your cabinet silver side in, or you can use it with a stand.First let me say what this mic is not: It's not a Shure 57. If you looked at a Shure 57 and thought "Everyone uses those, I should do some research!" and you have watched all the youtube videos showing you how to earn your degree in Shure 57 mic placement to get a killer tone out of one and you are ready to put your skills to the test, go for it. Amazon sells those, too.Or..... You can just lay this thing on the grille cloth about right where the dust cap (that dome in the center) meets the cone, and get a great sound. If you want it a bit warmer, move more toward the cone/edge, if you want it brighter, move toward the dust cap. About half way for a start, and it sounds pretty damn good, without all the fuss that a 57 takes.Does it sound as good as the 57? I think so. And without anywhere near as much fiddling around. I use mine at a "Loud enough, but not so loud the cops are coming" volume and I have no issues getting the tone I hear in the room coming out of my amp reproduced in the DAW.

Great tone

Serves it's purpose

Previously I was using the Sure 57 like every guitar player under the sun. But I could never achieve a "full" and "present" sound with the 57, and always had to crank my guitar channel up in the mix a bit higher than everyone else in the band. The Sennheiser Professional was a huge improvement. Now I can hear my guitar cutting through the mix clearly and fully. I also like the "drape down" method of mic placement on the amp speaker instead of having a mic stand getting in the way. You need this mic if you want your guitar channel to come alive.

These were recommended to me by a sound professional who uses them almost exclusively for mic'ing guitar amps and bass amps at live gigs. His comment about them is that they are as good for the job as a Shure SM58, but a lot easier to place. He just drops them over the front of amps and secures the cable with a little duct tape to the amp.I compared mine to SM58 and while I can hear a tiny bit more high end on the Shure, but not enough to make any difference to me. I now have two of these in my music room, permanently hanging in front of my amps and they will be used for all of my guitar and bass recording.Oh... the only negative I can find is that the mic clips for stand mounting simply can't be used with these microphones. The clips that came with the mics are far too small. And the mic bases are too small to snugly fit into a SM58 sized clip. I have some aftermarket mic clips that use a clothespin type of holder that will hold them. I won't need the clips, but if you do, it is something to be aware of.