Installation: • Clean the surface very well. • Hold the decal up to where you want to apply it. Go though the motion just as if you were installing the decal. This will aid in lining up the decal when applying it. • Remove the clear tape from the backing. The decal will adhere to the clear tape as the tape pulls away from the backing. Be very careful not to let the tape or decal stick to it's self while removing. • Hold the decal just above where you would like it applied. Gently allow the middle to touch the surface. Then let the edges down gently. • Use your fingers or other smooth object to scrape across the tape. Do this to remove any air bubbles and activate the glue. The decals are pressure sensitive so the more pressure you apply the better it will stick. • Gently start at one corner and pull the tape back at a very sharp angle. The tape should pull free of the decal leaving just the decal on the surface. If as you are pulling the vinyl does not want to adhere to the surface, let sit overnight and try again after it has longer to cure.
Trustpilot
2 days ago
1 week ago
2 days ago
2 months ago
