Pressure Cooker Pressure Sensor/Switch Replacement KSD105, KSD105A, YCD3005, YCD3008 for Instant Pot Duo, Duo Plus, Duo Crisp, Duo Evo Plus, Nova, Lux (KSD105A)

Worked perfectly and was already calibrated to the right pressure. Still, always check that before using it!

Arrived promptly, easy to fit and didn't require any calibrating. Fixed the issuue with the high pressure sensor so the unit is now fully functional again.Notes:1. Instant pots come with 4 variants of pressure sensor/switches, make sure you order the right one. There are those units that have the High and Low pressure sensors (two swictches in a sinbgle unit), such as the Duos, and those that have a single High pressure sensor (one switch). For each of these, there are two potential sizes of spade connector. Measure your existing spade connectors to make sure you order the correct one for your unit.2. Replacement is easy, but you should 'Google' how to do it. You should note which wires you disconnect go where. Any video or picture showing the replacement should show this, however if you are worried, consider taking a photo to refer to before removing the old one.3. You should ALWAYS inspect the sensor before fitting and run an operational safety test once fitted to ensure correct operation and calibration. Professionals have specialist equipment to measure the pressure, but luckily there is an easy water heating test that suffices. Again 'Google' how to do it. If you have not altered the calibration screw settings, removed anything else, and the sensor/switch is working ok, you should not need to calibrate. If not, you have the choice to try to calibrate (again, ‘Google’ instructions and keep in mind that if you have altered the calibration screws or removed/replaced any other related part you may have to recalibrate irrespective of the sensor) or return the sensor for a replacement.

Saved me $50 on a new pot. Works well and easy to install.

Product is described as pre-calibrated, but I had the dreaded C6H error code after a few uses. Luckily it resolved after leaving the appliance unplugged for 10 minutes. Hopefully it continues to work well, fingers crossed! It was easy to install and appears well made with good quality.

It was easy to change out and did not need calibration. It worked perfectly right out of the box, as opposed to most of the other sellers that send you uncalibrated units. This saved me from buying a new InstaPot!!!

Must be calibrated!!! 105 Switch has an adjustment that interferes with the Instant Pot adjustment and not exactly the same as original . Took a bit of study to solve. Back out switch adjusting screw, install switch with factory screw touching blade of new switch. Using adjustment on the IP bracket Screw in 1 turn rough adjustments to decrease temperature and pressure. Screw out to increase. Desired pressure is just below pop off release.

It was great to get a replacement thermostatic switch assembly that was an exact replacement and worked as promised. Our InstaPot is now functional! Easy installation!

Our Instant Pot started giving us the error code, after looking up the error code, found this part, replaced it according to a YouTube video, everything works fine.