POWERTEC 6" Large Toggle Clamp Foot with Nuts & Washers, Oversized Stud Clamp Foot Compatible with Toggle Clamps for Table Saw Fence, Drill Press Table, and Woodworking Jigs (71700)

I bought this for a 3D printed Roll-Crimp vise for reloading shotgun shells. It's a nice well made clamp that does exactly what it was designed to do.

This is a very well made clamp for an excellent piece. Thank you

Works great. built well , quality product . A little pricy for one clamp . but i only needed one.

Ordered these for a tool I was building - to hold a template and workpiece. Then used a trim router to complete the workpiece. the hold downs were smaller than I envisioned, but worked well. Four clamps held a on a stack of a 1/2 plywood template and corresponding workpiece securely, with easy out for the next piece.

solid good quality, good strong finish good price

Very useful size that allows installation where other toggle clamps are just too big. The clamp screw could be longer. Single hole for the pressure screw on my units. The fastening nuts are very soft and strip-out easily. I have to give 5 stars though because they fit my application perfectly. Other nuts are easy to come by. A clamp that would fit my space requirements was not.

These are not the regular size wagon brakes. They're fine, thought the handle doesn't stay locked if it is up.

As with the small pair of clamps, reviewed separately, these don't come with screws, or bolts, but I can figure something out, may need to get a second one, to make a pair. Also, easy to use and adjustable. Will come in helpful down the line, need to mount to a table, workbench, or a piece of wood, to make portable.

I have 2 of these clamps which will be used to build desk mounts almost identical to the very expensive name brands. The desk mounts are for a separate throttle and flight stick (HOTAS) for my flight simulator. The only other piece required to finish it is a small rubber furniture foot that can be purchased cheaply at most hardware stores. I am able to build the mounts with minimal tools and for about 1/3 the cost of the name brand mounts. For those interested simply google "DIY hotas mounts" or look at some images. I will include a few photos when the mounts are complete.

Error mio, no mire bien las especificaciones del vendedor (las cuales son muy claras), pero en material y resistencia están muy bien.

Looks good for my pocket hole jig, not built yet but will update when completed.

Fuerte y buen calidad

The centre of the cylinder is close to 3/4", which is mostly the wood thickness i work with. It would be better if the cylinder is 1/4" or 5-6mm lower.