Front Drum Bearing Felt Seal Compatible with Beko DRCS68S, DRCS68W, DRCS76B, DRCS76S, DRCS76W, DRVS62, DRVS62S, DRVS62W, DRVS73S, DRVS73W, TDF168S Tumble Dryers [Energy Class A+++]

If you are fitting this then replace drum guides at same time

Bought to replace the original seal which had perished on a Beko DRVS73W dryer, seal seemed slightly too short compared to original so I ended up reusing a good 2" section of the original belt and sticking it in with duct tape to make up the shortfall, otherwise good

Fitted my beko machine perfectly, instructions easily found on internet and much cheaper than buying a new machine! Still working with no problems after a few months of use

Don't buy this.It's about an inch too short for starters and not very good quality either. I've had my tumble dryer for over 10 years and the original seal has only just gone. This one lasted less than 2 minutes before it churned itself up and stopped the drum from spinning. It would have caused the (brand new) belt to burn out if I hadn't caught it in time.If you're looking at this and think oh I'm sure it's not that bad and I'll take a chance as it's cheap, don't. Get the more expensive genuine one.

Perfect did job a treat

seems to work well time will tell fitting easier than the cheaper endless type

Great and easy to fit

Right from delivery I could tell this wasn't a quality product. It was stuck to the packaging, the ends had been glued together and was too short, even shorter after cutting the glued ends apart.The quality felt cheap and upon using it for a couple of days you could see it had split and was showing inside the drum. Had to stick with it for and month and it's totally destroyed. This isn't the first time I've replaced a seal but it's the first time I've seen one fail this bad and this fast. Buy a better one.